Characterization and Modeling of Nonlinearities in In-Plane Gap Closing Electrostatic Energy Harvester
- 9 September 2015
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 24 (6) , 2071-2082
Abstract
This paper investigates in detail a micro scale in-plane gap closing electrostatic energy harvester with strong nonlinearities in squeeze-film damping, electromechanical coupling, and impacts on end-stops. The device shows softening response on increasing the bias voltage and saturation behavior on impact with end-stops at high enough acceleration amplitude. We demonstrate that a lumped model can adequately describe the measured nonlinear behavior for a range of operating conditions with nonlinear fluid damping force and impact force included in the model. While modeling capacitances, a finite-element method (FEM) is used to analyze fringing field effects on the capacitance variation for gap closing electrodes. The nominal capacitance is obtained from FEM analysis, for a range of under-cut values in the fabrication process treated as a free parameter in the model. The device modeled for linear and nonlinear squeeze-film damping force highlights the importance of nonlinear damping force to understand the device behavior over the range of operating conditions. With the compliant end-stops treated as spring-dampers and with proper choice of end-stop damping-coefficient, the model successfully captures the end-stop nonlinearities for a particular operating point and reproduces the dynamic pull-in phenomena at 8 V bias, and rms acceleration 0.6 g , as observed in the experiments. Thus, the model described in this paper reproduces the subtle nonlinear effects dominating the dynamics of an in-plane gap closing electrostatic energy harvester.Keywords
Funding Information
- Norges Forskningsråd (191282)
This publication has 28 references indexed in Scilit:
- Electrostatic pull-in instability in MEMS/NEMS: A reviewSensors and Actuators A: Physical, 2014
- Electrostatic vibration energy harvester with combined effect of electrical nonlinearities and mechanical impactJournal of Micromechanics and Microengineering, 2014
- Large-dynamic-range MEMS Electret Energy Harvester with Combined Gap-closing/Overlapping-area-change ElectrodesJournal of Physics: Conference Series, 2013
- Architecture-independent power bound for vibration energy harvestersJournal of Physics: Conference Series, 2013
- Analysis and characterization of triangular electrode structures for electrostatic energy harvestingJournal of Micromechanics and Microengineering, 2011
- On the jump-up and jump-down frequencies of the Duffing oscillatorJournal of Sound and Vibration, 2008
- A wideband vibration-based energy harvesterJournal of Micromechanics and Microengineering, 2008
- Characteristics of a commercially available silicon-on-insulator MEMS materialSensors and Actuators A: Physical, 2007
- Squeeze film air damping in MEMSSensors and Actuators A: Physical, 2007
- Capacitive pressure transducers and accelerometers2000