Removal of reactive textile dye from aqueous solutions by electrocoagulation in a continuous cell
Open Access
- 1 October 2016
- journal article
- research article
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (48-49) , 22764-22773
Abstract
In electrocoagulation (EC), coagulants are delivered in situ using the corrosion of sacrificial anodes when a DC voltage is applied. Simultaneously, electrolytic gases (H2) are generated at the cathode. Aluminum and iron materials are usually used as anodes, the dissolution of which produces hydroxides and polymeric hydroxides. These coagulants are able to destabilize colloidal suspensions and emulsions, to adsorb, neutralize, or precipitate dissolved polluting species, and finally to form flocs that can be removed either by settling or flotation. The purpose of this study was to investigate the effects of the operating parameters, such as initial pH, initial concentration (C0), residence time (τ), current density (j), and inlet flow rate (Q), on the removal of a red nylosan dye by EC process using aluminum electrode in a continuous electrochemical reactor. FTIR analysis was conducted to interpret the functional groups involved during the EC process. It was found that the increase in the current density up to 100 A m−2 had increased the dye removal efficiency and the optimum inlet flow rate for EC process was the minimum at 15 L h−1 and it has increased the electrical energy consumption. A rate of abatement of about 90% for turbidity and 97% for color was observed, when the initial concentration of the dye C0 was lower than 300 mg L−1, current density j = 300 A m−2, conductivity κ = 2.54 mS cm−1, inlet flow rate Q = 15 L h−1, residence time τ = 35 min, and initial pH ranged from 2.3 to 8.8. The specific electrical energy consumption was 19.5 kW h per kilogramme of removed dye.Keywords
This publication has 39 references indexed in Scilit:
- Removal of acid green dye 50 from wastewater by anodic oxidation and electrocoagulation—A comparative studyJournal of Hazardous Materials, 2010
- Electrocoagulation for the treatment of textile wastewaters with Al or Fe electrodes: Compared variations of COD levels, turbidity and absorbanceJournal of Hazardous Materials, 2009
- Removal turbidity and separation of heavy metals using electrocoagulation–electroflotation techniqueJournal of Hazardous Materials, 2009
- Removal of hexavalent chromium from industrial wastewater by electrocoagulation: A comprehensive comparison of aluminium and iron electrodesSeparation and Purification Technology, 2009
- Electrocoagulation/electroflotation in an external-loop airlift reactor—Application to the decolorization of textile dye wastewater: A case studyChemical Engineering and Processing - Process Intensification, 2008
- Arsenic removal by electrocoagulation using combined Al–Fe electrode system and characterization of productsJournal of Hazardous Materials, 2007
- Treatment of levafix orange textile dye solution by electrocoagulationJournal of Hazardous Materials, 2006
- Electrochemical technologies in wastewater treatmentSeparation and Purification Technology, 2004
- Treatment of orange II azo-dye by electrocoagulation (EC) technique in a continuous flow cell using sacrificial iron electrodesJournal of Hazardous Materials, 2004
- Olive oil mill wastewater treatment by means of electro-coagulationSeparation and Purification Technology, 2004