Deformation and secondary faulting associated with basement-involved compressional and extensional structures
Open Access
- 1 April 2011
- journal article
- Published by American Association of Petroleum Geologists AAPG/Datapages in AAPG Bulletin
- Vol. 95 (4) , 675-689
Abstract
Experimental clay modeling is used to study the geometry and evolution of deformation zones formed above basement faults. The nature of deformation is compared for reverse faults dipping 30, 45, and 60°, vertical faults, and normal faults dipping 60 and 75°. Basement faulting results in the formation of a sheared triangular deformation zone that widens upward in the cover units. Most of the deformation is focused within a central zone of secondary faults, which propagate upward and eventually break through the entire section. Basal units exhibit steeper dips and higher fault densities, whereas stratigraphically higher units exhibit gentler dips and lower fault densities. The width of the deformation zone is generally greater for reverse faults with low dips. The anticlinal axial surface typically dips in the same direction as the synclinal axial surface for low- to moderate-angle reverse faults; however, the axial surfaces dip in opposite directions for vertical faults and normal faults. Particle paths suggest a convex upward rotation within the deformation zone, suggesting transfer of material across the extension of the master fault. Reverse faults are associated with secondary faults with reverse and thrust separations. Vertical faults are associated with mostly vertical and reverse secondary faults, whereas normal faults are generally associated with normal separation of most secondary faults. Therefore, the nature of secondary faults varies with structural position, possibly within the same layer. These results provide some key insights that are useful in the interpretation of macroscopic surface and subsurface basement–involved structures.Keywords
This publication has 26 references indexed in Scilit:
- Trishear kinematic modeling of extensional fault-propagation foldingJournal of Structural Geology, 2006
- Mechanical analysis of the geometry of forced-foldsJournal of Structural Geology, 2002
- Velocity field for the trishear modelJournal of Structural Geology, 2000
- Inverse and forward numerical modeling of trishear fault‐propagation foldsTectonics, 1998
- Numerical modeling of trishear fault propagation foldingTectonics, 1997
- Evolution of fault patterns in clay experimentsTectonophysics, 1988
- Deformation near a fault termination, part I: A fault in a clay experimentTectonophysics, 1979
- The mechanism of faulting in clay experimentsTectonophysics, 1965
- ANALYTICAL AND EXPERIMENTAL STUDY OF SIMPLE GEOLOGIC STRUCTURESGeological Society of America Bulletin, 1959
- Theory of scale models as applied to the study of geologic structuresGeological Society of America Bulletin, 1937