Structure and its defects in additive manufacturing of stainless steels by laser melting and electric arc surfacing
Authors:
Open Access
- 25 February 2024
- journal article
- research article
- Published by National University of Science and Technology MISiS in Izvestiya. Ferrous Metallurgy
- Vol. 67 (1) , 65-72
Abstract
Currently, there is an active development and study of additive technologies. Metal 3D printing makes it possible to obtain parts and structures of complex configuration using a minimum of shaping operations, which can lead to a reduction in overall cost of the resulting products. In this paper, we studied the structure formation in manufacture of products made of stainless steels 10Cr12Ni10Ti (analogue of AISI 321) and 08Cr18Ni9 (analogue of AISI 304) by additive methods – SLM (Selective Laser Melting) and WAAM (Wire Arc Additive Manufacturing). In the course of microstructural analysis, it was found that during the manufacture of products using SLM technology, small austenitic grains oriented in the direction of heat removal are formed, and with WAAM method, austenite is formed mainly in form of dendrites. It is shown that porosity is formed during manufacture of the samples by SLM method, which is associated with non-melting of individual powder particles. When implementing additive manufacturing by WAAM (electric arc surfacing), there is no increased porosity. In the course of the study, a new defect of the structure formed during the manufacture of products by both methods was revealed – formation of interface boundaries between layers, which is associated with the technology of additive manufacturing itself. When manufacturing a WAAM product, it manifests itself more clearly than when obtaining metal by SLM. Boundaries of the surfacing rollers in the manufacture of products by SLM accumulate various intermetallides and structural defects more intensively, relative to WAAM. As a result of the small relative volume of one surfacing roller, compared with WAAM, accumulation of these defects and intermetallides can act as an effective barrier during movement of dislocations, which can lead to an increase in the strength properties of products.Keywords
This publication has 13 references indexed in Scilit:
- Structure formation of Np-30KhGSA alloy in wire and arc additive manufacturingIzvestiya. Ferrous Metallurgy, 2023
- Mechanical Properties and Fracture of Austenitic Steel Fabricated by Selective Laser MeltingRussian Metallurgy (Metally), 2022
- Study of the Influence of Main Parameters of the Selective Laser Melting Process on the Porosity of Aluminum Alloy RS-300 SamplesProceedings of Higher Educational Institutions. Маchine Building, 2022
- Heat treatment effect on the microstructure, mechanical properties, and wear behaviors of stainless steel 316L prepared via selective laser meltingMaterials Science and Engineering: A, 2021
- Correlation of Microstructural Evolution with Mechanical and Tribological Behaviour of SS 304 Specimens Developed Through SLM TechniqueMetals and Materials International, 2021
- Defects, densification mechanism and mechanical properties of 300M steel deposited by high power selective laser meltingAdditive Manufacturing, 2021
- A high-performance WAAM process for Al–Mg–Mn using controlled short-circuiting metal transfer at increased wire feed rate and increased travel speedMaterials & Design, 2020
- Influence of heat treatment temperature on the microstructural, mechanical, and wear behavior of 316L stainless steel fabricated by laser powder bed additive manufacturingThe International Journal of Advanced Manufacturing Technology, 2020
- The effect of plastic deformation and subsequent heat treatment on the acoustic and magnetic properties of 12Khl8N10T steelZavodskaya Laboratoriya. Diagnostika Materialov, 2019
- Cost Modelling and Sensitivity Analysis of Wire and Arc Additive ManufacturingProcedia Manufacturing, 2017