Effective DQE (eDQE) and speed of digital radiographic systems: An experimental methodology
Authors:
- Ehsan SameiESEhsan Samei
- Nicole T. RangerNRNicole T. Ranger
- Alistair MacKenzieAMAlistair MacKenzie
- Ian D. HoneyIHIan D. Honey
- James T. DobbinsJDJames T. Dobbins
- Carl E. RavinCRCarl E. Ravin
- 23 July 2009
- journal article
- Published by Wiley in Medical Physics
- Vol. 36 (8) , 3806-3817
Abstract
Prior studies on performance evaluation of digital radiographic systems have primarily focused on the assessment of the detector performance alone. However, the clinical performance of such systems is also substantially impacted by magnification, focal spot blur, the presence of scattered radiation, and the presence of an antiscatter grid. The purpose of this study is to evaluate an experimental methodology to assess the performance of a digital radiographic system, including those attributes, and to propose a new metric, effective detective quantum efficiency (eDQE), a candidate for defining the efficiency or speed of digital radiographic imaging systems. The study employed a geometric phantom simulating the attenuation and scatter properties of the adult human thorax and a representative indirect flat-panel-based clinical digital radiographic imaging system. The noise power spectrum (NPS) was derived from images of the phantom acquired at three exposure levels spanning the operating range of the clinical system. The modulation transfer function (MTF) was measured using an edge device positioned at the surface of the phantom, facing the x-ray source. Scatter measurements were made using a beam stop technique. The eDQE was then computed from these measurements, along with measures of phantom attenuation and x-ray flux. The MTF results showed notable impact from the focal spot blur, while the NPS depicted a large component of structured noise resulting from use of an antiscatter grid. The eDQE was found to be an order of magnitude lower than the conventional DQE. At 120 kVp, eDQE(0) was in the 8%-9% range, fivefold lower than DQE(0) at the same technique. The eDQE method yielded reproducible estimates of the system performance in a clinically relevant context by quantifying the inherent speed of the system, that is, the actual signal to noise ratio that would be measured under clinical operating conditions.Keywords
Funding Information
- National Institutes of Health (R01CA109074, R01CA80490)
This publication has 26 references indexed in Scilit:
- Assessment of Detective Quantum Efficiency: Intercomparison of a Recently Introduced International Standard with Prior Methods1Radiology, 2007
- A comparison of the performance of digital mammography systemsMedical Physics, 2007
- Comparison of different commercial FFDM units by means of physical characterization and contrast‐detail analysisMedical Physics, 2006
- Intercomparison of methods for image quality characterization. II. Noise power spectruma)Medical Physics, 2006
- Intercomparison of methods for image quality characterization. I. Modulation transfer functiona)Medical Physics, 2006
- Measurement of the detective quantum efficiency (DQE) of digital X-ray detectors according to the novel standard IEC 62220-1Radiation Protection Dosimetry, 2005
- Generalizing the MTF and DQE to include x-ray scatter and focal spot unsharpness: Application to a new microangiographic systemMedical Physics, 2005
- Study of the generalized MTF and DQE for a new microangiographic systemProceedings of SPIE, 2004
- Standardization of NPS measurement: interim report of AAPM TG162003
- Analysis of the significance of scattered radiation in reduced dose mammography, including magnification effects, scatter suppression, and focal spot and detector blurringMedical Physics, 1979