The Truth About 2-Level Transition Elimination in Bang-Bang PAM-4 CDRs
- 30 October 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 68 (1) , 469-482
Abstract
Reception of 4-level pulse amplitude modulation (PAM-4) requires a clock and data recovery (CDR) circuit, typically implemented by a PLL-like structure. An essential block in such a CDR is the phase detector which should detect whether the recovered clock leads or lags the incoming data edges. In typical implementations an incoming data edge is detected by sensing whether the incoming waveform crosses a data threshold level. However, there is some ambiguity in detecting the incoming data edge because PAM-4 modulation has 3 thresholds. If the waveform crosses multiple threshold levels, the level crossings will occur at different time instants due to the finite rise/fall time of the incoming waveform. In this work, we first analyze qualitatively and quantitatively CDR systems that use one threshold for phase adjustment. Here, eliminating the 2-level transitions decreases the amount of jitter injected by the phase detector. However, the available transitions for phase adjustment are also reduced, which lowers the CDR's robustness. Secondly, for CDR systems using three thresholds, a combination of two techniques: majority voting and elimination of 2-level transitions is investigated. We prove that in this case, the elimination of 2-level transitions is not needed and even gives a worse performance when implemented.Keywords
This publication has 29 references indexed in Scilit:
- A 1.8-pJ/b, 12.5–25-Gb/s Wide Range All-Digital Clock and Data Recovery CircuitIEEE Journal of Solid-State Circuits, 2017
- A 40 Gb/s 74.9 mW PAM4 receiver with novel clock and data recovery2017
- Design of 56 Gb/s NRZ and PAM4 SerDes Transceivers in CMOS TechnologiesIEEE Journal of Solid-State Circuits, 2015
- Influence of Jitter on Limit Cycles in Bang-Bang Clock and Data Recovery CircuitsIEEE Transactions on Circuits and Systems I: Regular Papers, 2015
- A 22-Gb/s PAM-4 Receiver in 90-nm CMOS SOI TechnologyIEEE Journal of Solid-State Circuits, 2006
- SiGe BiCMOS PAM-4 clock and data recovery circuit for high-speed serial communications2004
- Equalization and clock recovery for a 2.5-10-Gb/s 2-PAM/4-PAM backplane transceiver cellIEEE Journal of Solid-State Circuits, 2003
- Clock recovery in high-speed multilevel serial links2003
- An adaptive pam-4 5-Gb/s backplane transceiver in 0.25-μm CMOSIEEE Journal of Solid-State Circuits, 2003
- Clock recovery from random binary signalsElectronics Letters, 1975