The Effects of Unsteadiness and Compressibility on the Interaction Between Hub Leakage and Mainstream Flows in High-Pressure Turbines
Authors:
- Ivan PopovićIPIvan Popović
- Erik JankeEJErik Janke
- 13 September 2013
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 135 (6) , 061015
Abstract
This paper investigates the effects of compressibility and unsteadiness due to the relative blade row motion and their importance in the interaction between hub leakage (purge) and mainstream flows. First, the challenges associated with the blade redesign for low-speed testing are described. The effects of Mach number are then addressed by analyzing the experiments in the low-speed linear cascade equipped with the secondary airflow system and computations performed on the low- and high-speed blade profiles. These results indicate that the compressibility does not significantly affect the interaction between the leakage and mainstream flows despite a number of compromises made during the design of the low-speed blade. This was due to the fact that the leakage–mainstream interaction takes place upstream of the blade throat where the local Mach numbers are still relatively low. The analysis is then extended to the equivalent full-stage unsteady computations. The periodic unsteadiness resulting from the relative motion of the upstream vanes appreciably affected the way in which the leakage flow is injected and the rotor flow field in general. However, the time-average flow field was still found to be dominated by the rotor blade's potential field. For the present test arrangement, the unsteady effects were not very detrimental and caused less than a 10% increase in the losses due to the leakage injection relative to the steady calculations.Keywords
This publication has 18 references indexed in Scilit:
- The Influence of Different Rim Seal Geometries on Hot-Gas Ingestion and Total Pressure Loss in a Low-Pressure Turbine2010
- Influence of Rim Seal Purge Flow on Performance of an Endwall-Profiled Axial Turbine2009
- The Effect of Stator-Rotor Hub Sealing Flow on the Mainstream Aerodynamics of a Turbine2006
- Effect of the Leakage Flows and the Upstream Platform Geometry on the Endwall Flows of a Turbine Cascade2006
- Film Cooling Effectiveness Distribution on a Gas Turbine Blade Platform With Inclined Slot Leakage and Discrete Film Hole Flows2006
- Aerothermal Investigations on Turbine Endwalls and Blades (AITEB)2004
- Pressure Surface Separations in Low-Pressure Turbines—Part 1: Midspan BehaviorJournal of Turbomachinery, 2002
- Mainstream Aerodynamic Effects Due to Wheelspace Coolant Injection in a High-Pressure Turbine Stage: Part I—Aerodynamic Measurements in the Stationary FrameJournal of Turbomachinery, 2001
- Axial Flow Compressor and Turbine Loss Coefficients: A Comparison of Several ParametersJournal of Engineering for Power, 1972
- The Fluid Dynamics of a Shrouded Disk System With a Radial Outflow of CoolantJournal of Engineering for Power, 1970