A New Theory for Locating Line Fault in Power System: Theoretical Part
Open Access
- 5 July 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 91337-91346
Abstract
This paper proposes a theory for locating line fault based on the basic principle of time reversal. The proof has five steps. Firstly, the theoretical voltage and current at the ends of the line are calculated based on the transmission equation of the line in the additional network after line fault occurred. Secondly, the loss and lossless mirror line are established according to the parameters of the actual line, respectively. Thirdly, the values of the implemented sources at the ends of the mirror line are calculated based on the conjugate complex of the theoretical values of voltage and current in the first step. Fourthly, the RMS value of the fault current is calculated by assuming that fault occurs at every point of the mirror line. Finally, we should identify that there is only one peak value among all the RMS values and it exists at the actual fault location. In this paper, the fault location theory is proved with and without reflected waves by using the transmission equation of a single line. It is further proved in the mixed line that consists of two lines of different parameters considering the reflections.Keywords
Funding Information
- National Natural Science Foundation of China (51877135)
- National Key Research and Development Program of China (2016YFB0900601)
- Shanghai Rising-Star Program (18QA1402100)
- Key Laboratory of Control of Power Transmission and Conversion (SJTU), Ministry of Education (2015AB04)
This publication has 29 references indexed in Scilit:
- Multi‐terminal medium voltage DC grids fault location and isolationIET Generation, Transmission & Distribution, 2016
- DC Fault Detection and Location in Meshed Multiterminal HVDC Systems Based on DC Reactor Voltage Change RateIEEE Transactions on Power Delivery, 2016
- Traveling-Wave-Based Fault-Location Algorithm for Hybrid Multiterminal CircuitsIEEE Transactions on Power Delivery, 2016
- Fault detection, classification and location for transmission lines and distribution systems: a review on the methodsHigh Voltage, 2016
- Traveling Wave-Based Fault Location on Half-Wavelength Transmission LinesIEEE Latin America Transactions, 2016
- Application of signal processing and analysis in detecting single line‐to‐ground (SLG) fault location in high‐impedance grounded distribution networkIET Generation, Transmission & Distribution, 2016
- An Automatic Faulted Line Section Location Method for Electric Power Distribution Systems Based on Multisource InformationIEEE Transactions on Power Delivery, 2015
- Time-Domain Fault-Location Method on HVDC Transmission Lines Under Unsynchronized Two-End Measurement and Uncertain Line ParametersIEEE Transactions on Power Delivery, 2015
- Fault Location in Distribution Networks by Compressive SensingIEEE Transactions on Power Delivery, 2014
- Modeling of Multi-Terminal VSC HVDC Systems With Distributed DC Voltage ControlIEEE Transactions on Power Systems, 2013