Flow Characteristics of Bulb Tubular Turbine Based on Solid-liquid Two-phase Flow Model
Authors:
Open Access
- 1 August 2025
- journal article
- Published by Academic World Research in Journal of Applied Fluid Mechanics
- Vol. 18 (8) , 2137-2148
Abstract
This study examines the operational efficiency of a bulb tubular turbine under solid-liquid two-phase (SLTP) flow conditions. By employing the Euler-Euler method, the characteristics of SLTP flow in the turbine with different solid particle diameters were analyzed. The research findings demonstrate that the increase in solid particle diameter from 0.01 mm to 0.15 mm decreases the maximum liquid phase velocity in the XY plane by approximately 0.26%. The introduction of solid particles results in increased likelihood of cavitation and vortices in the draft tube region, leading to diminished energy recovery efficiency in this area. Within the impeller domain, regions with high solid particle concentration are predominantly located on the blade front hub and inlet edge, while the blade's rear side exhibits an overall higher concentration. Further analysis reveals a positive correlation between blade velocity/concentration distribution and the diameter of solid particles. Furthermore, particle size has a significant impact on the solid phase trajectory and solid phase velocity in the draft tube area. Particles with larger diameters tend to move in more irregular and chaotic patterns, promoting the formation of vortices in the draft tube region. Notably, while the velocity of the solid phase at the draft tube inlet decreases with increasing particle size, the velocity fluctuations within the draft tube become more pronounced. Among the different flow components of the hydraulic turbine, the wear severity follows a descending order: the blade region experiences the highest wear, followed by the runner chamber, guide vane area, and draft tube region. Additionally, the diameter of the solid phase shows a positive correlation with both the wear area and the maximum wear rate in the runner chamber, blade region, and guide vane area, whereas it demonstrates a negative correlation with wear in the draft tube region.Keywords
This publication has 20 references indexed in Scilit:
- Spare parts management analytics for smart maintenance: A review on dealing with challenges to warranty profitabilityAIP Conference Proceedings, 2023
- Measured viscosity characteristics of Fe3O4 ferrofluid in magnetic and thermal fieldsPhysics of Fluids, 2023
- Influence of the solution pH on the design of a hydro-mechanical magneto-hydraulic sealing deviceEngineering Failure Analysis, 2022
- Improved dynamic model of a bulb turbine-generator for analysing oscillations caused by mechanical torque disturbance on a runner bladeInternational Journal of Electrical Power & Energy Systems, 2020
- Procedure for predicting part load resonance in Francis turbine hydropower units based on swirl number and local cavitation coefficient similitudeMechanical Systems and Signal Processing, 2019
- Effects of surface functionalization on the flow boiling heat transfer characteristics of MWCNT/R141b nanorefrigerants in smooth tubeExperimental Thermal and Fluid Science, 2018
- Micromechanical Study of Cyclically Loaded Sands with x-ray Microtomography and Digital Image CorrelationProcedia Engineering, 2016
- Velocity field investigation inside a bulb turbine runner using endoscopic PIV measurementsExperiments in Fluids, 2015
- Biofuels and biochemicals production from forest biomass in Western CanadaEnergy, 2011
- Développement systématique et outils CAO pour la petite hydrauliqueLa Houille Blanche, 2003