High-Efficiency Digital-Controlled Interleaved Power Converter for High-Power PEM Fuel-Cell Applications
Authors:
- 6 July 2012
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 60 (2) , 773-780
Abstract
A high-efficiency digital-controlled interleaved dc-dc converter is designed and implemented to provide a regulated high voltage output for high-power proton-exchange-membrane fuel-cell applications. Ripple cancellation on input current and output voltage can be achieved by the studied interleaved dc-dc power conversion technique to reduce hysteresis energy losses inside the fuel-cell stacks and meet battery charging considerations on the high-voltage dc bus. An active-clamped circuit is also used to reduce the voltage spike on the power switches for raising the system reliability. The operation principles and the design considerations of the studied power converter are analyzed and discussed in detail. Finally, a 10-kW laboratory prototype is built and tested. The experimental results are shown to verify the feasibility of the proposed scheme.Keywords
This publication has 26 references indexed in Scilit:
- Efficiency Optimization of a DSP-Based Standalone PV System Using Fuzzy Logic and Dual-MPPT ControlIEEE Transactions on Industrial Informatics, 2012
- Battery ripple current reduction in a three-phase interleaved dc-dc converter for 5kW battery charger2011
- PEM fuel cell and battery hybrid power supply system design based on fuel flow rate control2011
- Optimized active-clamp circuit design for an isolated full-bridge current-fed DC-DC converter2011
- A Three-Phase Current-Fed Push–Pull DC–DC Converter With Active Clamp for Fuel Cell ApplicationsIEEE Transactions on Power Electronics, 2010
- Analysis of PEM fuel cell – Supercapacitor – Battery pack system during standard cycle2010
- A Dynamic Model of a PEM Fuel Cell System2009
- A Three-Phase Current-Fed DC/DC Converter With Active Clamp for Low-DC Renewable Energy SourcesIEEE Transactions on Power Electronics, 2008
- Lithium-ion battery charger for high energy application2005
- Cost/benefit analyses of a new battery pack management technique for telecommunication applications: future directions with fuel cell/battery systems2005