Small signal analysis and control design of current-fed full-bridge isolated dc/dc converter with active-clamp
Authors:
- 1 May 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 4 (21635137) , 509-514
Abstract
This paper presents a systematic derivation of small signal model of current-fed isolated full-bridge dc/dc converter with an active clamp. Active-clamp is an active snubber helps to absorb turn off voltage spike across the power semiconductor devices, thus limiting or clamping the voltage across the devices. Inherently, it results in zero-voltage-switching (ZVS) of all devices (main and auxiliary) resulting in low switching losses and higher efficiency. State space averaging technique is used to derive the small signal model. A fixed frequency two-loop average current control with fixed frequency duty cycle modulation is designed to operate the converter for wide variation of load (1:10) and input voltage (1:2). A design procedure is illustrated. Frequency response curves using MATLAB and simulation results using PSIM 9.0 are presented to verify the stability of the control system as well as to observe the transient response with step-change in load and input voltage.Keywords
This publication has 16 references indexed in Scilit:
- Analysis and design of zero-voltage-switching current-fed isolated full-bridge Dc/Dc converter2011
- Small signal analysis and closed loop control design of active-clamped zero-voltage switched two inductor current-fed isolated DC–DC converterIET Power Electronics, 2011
- Current-fed full bridge converter for fuel cell systems2008 IEEE Power Electronics Specialists Conference, 2008
- A High-Efficiency 5-kW Soft-Switched Power Conditioning System for Low-Voltage Solid Oxide Fuel Cells2007
- Small-signal analysis of a soft-switching, single-stage two-switch AC-to-DC converter2002
- High performance predictive dead-beat digital controller for DC power suppliesIEEE Transactions on Power Electronics, 2002
- Design issues for digital control of boost power factor correction converters2002
- Full-bridge isolated current fed converter with active clamp1999
- Fast controller design for single-phase power-factor correction systemsIEEE Transactions on Industrial Electronics, 1997
- Design of a simple high-power-factor rectifier based on the flyback converter1990