Current-fed full bridge converter for fuel cell systems
Authors:
- 1 June 2008
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2008 IEEE Power Electronics Specialists Conference
- No. 02759306,p. 866-872
Abstract
This paper deals with a single phase current- fed full bridge converter with high voltage gain for fuel cell applications. The clamping circuit is implemented by an auxiliary buck converter. An analytical investigation is given, describing the operating behaviour of the converter completely. This includes a distinction of the three operating modes: continuous mode, discontinuous mode and buck mode. With the results, the impact of the input inductor choke, the transformer's winding ratio and its leakage inductance, the switching frequency and the output current on the voltage gain is emphasised. The theoretical limit of the transferable power is identified and considerations for an optimised converter design are given. To approve the analytical results, simulations are done and compared to the calculations. A 1.2 kW prototype was built and experimental results are given in this paper.Keywords
This publication has 10 references indexed in Scilit:
- A Novel Three-Phase High Power Current-Fed DC/DC Converter with Active Clamp for Fuel Cells2007
- Analysis of a Voltage-fed Full Bridge DC-DC Converter in Fuel Cell Systems2007
- Current-Fed Full Bridge Converters for Fuel Cell Systems Connected to the Three Phase Grid2006
- Analysis and Implementation of a High Efficiency, Interleaved Current-fed Full Bridge Converter for Fuel Cell System2006
- Voltage Fed and Current Fed Full Bridge Converter for the Use in Three Phase Grid Connected Fuel Cell Systems2006
- Fuel Cell Power System and High Power DC–DC converterIEEE Transactions on Power Electronics, 2004
- Fuel cellsEngineering Science & Education Journal, 2002
- Fuel cell systems: efficient, flexible energy conversion for the 21st centuryProceedings of the IEEE, 2001
- Full-bridge isolated current fed converter with active clamp1999
- A comparison of high-power DC-DC soft-switched converter topologiesIEEE Transactions on Industry Applications, 1996