Design of Boost-Type Power Factor Correction With Stepped Air-Gap Ferrite Inductor for Peak-Power-Load Condition
Open Access
- 30 May 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 57655-57664
Abstract
This paper presents the designed method and the implementation of stepped air-gap ferrite inductor applied in power factor correction (PFC). Conventionally, the input inductor of the PFC has a designed consideration on the maximum output power; thus, designing the PFC for peak-power-load conditions results in a very large inductor. The proposed designed method improves the load-carrying capability without increasing the volume of the inductor when the PFC is operating in peak-power-load conditions. The stepped air-gap ferrite inductor maintains the inductance in the rated-full-load and sustains the peak-power-load conditions with the lower inductance. Compared with the convectional ferrite inductor, the proposed method can maintain the size and the efficiency of the power supply, and promote the power-carrying ability. The detailed analysis and the design of the proposed method are described. Experimental results are recorded and evaluated by a prototype PFC with an AC input voltage of 110–264 VAC and a DC output voltage of 384 VDC. Finally, the volume of input inductor is kept with 40950 mm2, the efficiency is also same compared with the conventional inductor, and the load-carrying capability of the converter is promoted from the normal rated power of 1 kW to the peak power load of 2 kW.Keywords
This publication has 22 references indexed in Scilit:
- A Novel Method to Predict the Real Operation of Ferrite Inductors With Moderate Saturation in Switching Power Supply ApplicationsIEEE Transactions on Power Electronics, 2015
- Evaluation of High-Current Toroid Power Inductor With NdFeB Magnet for DC–DC Power ConvertersIEEE Transactions on Industrial Electronics, 2015
- Core loss characteristics analysis of power transformer under different frequencies excitation2013
- Inductor saturation detection with anti-saturation control strategy applied2013
- Quasi-active power factor correction with a variable inductive filter: theory, design and practiceIEEE Transactions on Power Electronics, 2003
- Design consideration for power factor correction boost converter operating at the boundary of continuous conduction mode and discontinuous conduction mode2002
- A study of power correction boost converter operating at CCM-DCM mode2002
- Power factor correction for AC-DC converters with cost effective inductive filtering2002
- Output voltage and power limits in boost power factor corrector operating in discontinuous inductor current modeIEEE Transactions on Power Electronics, 2000
- Simplified analysis of PWM converters using model of PWM switch. Continuous conduction modeIEEE Transactions on Aerospace and Electronic Systems, 1990