Investigation on the Attainment of High-Density 316L Stainless Steel with Selective Laser Sintering
Open Access
Abstract
Due to the low density of the green part produced by selective laser sintering (SLS), previous reports mainly improve the sample’s density through the infiltration of low-melting metals or using isostatic pressing technology. In this study, the feasibility of preparing high-density 316L stainless steel using 316L and epoxy resin E-12 as raw materials for SLS combined with debinding and sintering was investigated. The results indicated that in an argon atmosphere, high carbon and oxygen contents, along with the uneven distribution of oxygen, led to the formation of impurity phases such as metal oxides, including Cr2O3 and FeO, preventing the effective densification of the sintered samples. Hydrogen-sintered samples can achieve a high relative density exceeding 98% without losing their original design shape. This can be attributed to hydrogen’s strong reducibility (effectively reducing the carbon and oxygen contents in the samples, improving their distribution uniformity, and eliminating impurity phases) and hydrogen’s higher thermal conductivity (about 10 times that of argon, reducing temperature gradients in the sintered samples and promoting better sintering). The microstructure of the hydrogen-sintered samples consisted of equiaxed austenite and ferrite phases. The samples exhibited the highest values of tensile strength, yield strength, and elongation at 1440 °C, reaching 513.5 MPa, 187.4 MPa, and 76.1%, respectively.Keywords
This publication has 53 references indexed in Scilit:
- Effect of porosity and density on the mechanical and microstructural properties of sintered 316L stainless steel implant materialsMaterials & Design (1980-2015), 2014
- Oxide Transformation in Cr-Mn-Prealloyed Sintered Steels: Thermodynamic and Kinetic AspectsMetallurgical and Materials Transactions A, 2013
- Additive manufacturing of alumina parts by indirect selective laser sintering and post processingJournal of Materials Processing Technology, 2013
- Effect of process parameters on surface oxides on chromium-alloyed steel powder during sinteringMaterials Chemistry and Physics, 2013
- On-line control of processing atmospheres for proper sintering of oxidation-sensitive PM steelsJournal of Materials Processing Technology, 2012
- Surface composition of the steel powders pre-alloyed with manganeseApplied Surface Science, 2010
- Manufacturing AISI304 metal parts by indirect selective laser sintering combined with isostatic pressingThe International Journal of Advanced Manufacturing Technology, 2007
- Investigation into manufacturing Fe–Cu–C alloy parts through indirect selective laser sinteringMaterials Science and Technology, 2007
- Research on manufacturing Cu matrix Fe-Cu-Ni-C alloy composite parts by indirect selective laser sinteringThe International Journal of Advanced Manufacturing Technology, 2006
- Numerical Simulation of Sintering Shrinkage Behavior of Stainless-Steel-Powder Compact.Journal of the Japan Society of Powder and Powder Metallurgy, 1996