Modular Finite Element Modeling of Heavy Plate Rolling Processes Using Customized Model Reduction Approaches
Open Access
Abstract
Heavy plates are indispensable semi-finished products. Quality is strongly linked with production, so the rolling process must be performed within well-defined narrow tolerances. To meet this challenge, adequate modeling has become a necessity. In contrast to continuous strip rolling, where the workpiece can be modeled as a semi-infinite strip and 2D modeling can be argued quite well, this strategy is insufficient for the comprehensive modeling of heavy plate rolling. The geometry of the heavy plate favors an inhomogeneous distribution of relevant state variables, such as temperature. In addition, if the process involves longitudinal and spreading passes, the required plate rotation spoils the assumption of a symmetric arrangement that might have been acceptable before rotation. Consequently, the derivation of suitably reduced models is not trivial, and modeling tailored to the specific objective of investigation is of utmost importance. Models intended to resolve the evolution of inhomogeneities in the field variables are demanding and computationally expensive. An effective modular modeling strategy was developed for such models to be used offline. Mutually complementing and interchangeable modules may constitute an efficient modeling strategy valid for the specific subject of interest. The presented approach reduces the enormous cost of complete 3D simulation as much as the model purpose allows for.Keywords
Funding Information
- COMET-K2 Center of the Linz Center of Mechatronics (LCM) (886468 (FFG))
- Johannes Kepler Open Access Publishing Fund (886468 (FFG))
- federal state of Upper Austria (886468 (FFG))
- University of Linz (886468 (FFG))
This publication has 29 references indexed in Scilit:
- Comparison of Dynamic Recrystallization in Blooms between Conventional Rolling and Hot‐Core Heavy Reduction Rolling ProcessSteel Research International, 2023
- Study on the effects of initial temperature and thickness ratio of component metals on the preparation of aluminum/steel clad plates by the new different temperature rolling methodJournal of Manufacturing Processes, 2023
- Optimized shearing strategy for heavy plate based on contour recognitionJournal of Iron and Steel Research International, 2023
- Toward a 2D/3D Finite‐Element–Based Digital Shadow for the Approximation of Metrologically Inaccessible Dynamic Fields of State Variables during Heavy Plate RollingSteel Research International, 2023
- Modeling and Simulation of Steel Rolling with Microstructure Evolution: An OverviewSteel Research International, 2022
- Temperature Influence on Section Uniformity of Casting Steel Rolled with the Hot-Core Heavy Reduction Rolling Process and Traditional Hot Rolling ProcessJournal of Materials Engineering and Performance, 2022
- Recalculation of Flow Stresses from Industrial Process Data for Heavy Plate Rolling Using a 2D Finite Element ModelSteel Research International, 2012
- Simulation of central crack closing behavior during ultra-heavy plate rollingComputational Materials Science, 2009
- Evaluation of the inelastic heat fraction in the context of microstructure-supported dynamic plasticity modellingInternational Journal of Impact Engineering, 2008
- 3D FEM simulation of stationary metal forming processes with applications to slitting and rollingJournal of Materials Processing Technology, 2004