Comparison of Dynamic Recrystallization in Blooms between Conventional Rolling and Hot‐Core Heavy Reduction Rolling Process
- 9 July 2023
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 94 (10)
Abstract
Hot‐core Heavy Reduction Rolling (HHR2) is a new technology that improves the core quality of blooms by using a heavy reduction roller at the solidification end. Dynamic recrystallization (DRX) is expected to optimize the microstructure in this process. But the difference of DRX characteristic between HHR2 and conventional hot rolling (CHR) is an unclear problem. Herein, the differences of DRX behavior between two rolling processes are studied. If two rolling processes are carried out under the same deformation temperature and strain rate, the work hardening in CHR samples is greater than that in HHR2. Moreover, DRX occurrence in HHR2 lags behind the CHR process due to lower growth rate of dislocation density achieved in HHR2. By using DRX models, the DRX area and DRX volume fractions in bloom are calculated. The great temperature gradient and low strain rate decrease the DRX critical strain in the HHR2 process. The DRX region is mainly around the core of the HHR2 bloom, where the DRX volume fraction achieves 41.8%. The maximum value of DRX volume fraction in CHR bloom only achieves 20.1% because the great strain rate and uniform temperature lead to a low level of deformation permeability.Keywords
Funding Information
- National Natural Science Foundation of China (52274062)
This publication has 14 references indexed in Scilit:
- A unified dislocation density-based model for an aged polycrystalline Ni-based superalloy considering the coupled effects of complicate deformation mechanisms and initial δ phaseMaterials Science and Engineering: A, 2021
- Effect of a Novel Hot-core Heavy Reduction Rolling Process after Complete Solidification on Deformation and Microstructure of Casting SteelISIJ International, 2019
- Work Roll Surface Profile Design and Optimization for Hot-core Heavy Reduction Rolling ProcessISIJ International, 2019
- Comparison of porosity alleviation with the multi-roll and single-roll reduction modes during continuous castingJournal of Materials Processing Technology, 2019
- Evolution of Austenite Grain Size in Continuously Cast Slab during Hot‐Core Heavy Reduction Rolling Process Based on Hot Compression TestsSteel Research International, 2018
- Thermo-Mechanical Behavior of the Continuous Casting Bloom in the Heavy Reduction ProcessJOM, 2016
- Analysis and Application of Soft Reduction Amount for Bloom Continuous Casting ProcessISIJ International, 2014
- Dynamic Recrystallization (DRX) Analysis of Heavy Reduction Process with Extra‐Thickness SlabsSteel Research International, 2013
- Using a Two-Phase Columnar Solidification Model to Study the Principle of Mechanical Soft Reduction in Slab CastingMetallurgical and Materials Transactions A, 2011
- A new criterion for internal crack formation in continuously cast steelsMetallurgical and Materials Transactions B, 2000