Embedded-IC package using Si-interposer for mmWave Applications
- 1 May 2022
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2050-2057
Abstract
In this study, we optimized the interconnection of a Si-embedded IC package using a dummy IC that includes a transmission line. We also propose an improved process method to minimize the insulator effect on the chip for W-band applications. The 30-μm-thick insulator (ε r = 3.2) covering the dummy IC increases the ε eff by about 5.6%, and the reflection loss is increased by 5 dB or more. In the improved process, the insulator on the circuit area is removed by using a photosensitive material (WPR-1201). In the structure, the phase difference is improved by about 5% compared to the existing process, and there is little effect of reflection loss. The analyzed chip-to-chip (CTC) interconnection with a length of 320 μm was designed with a grounded coplanar waveguide (G-CPW), and the line width was optimized for the dielectric constant and substrate height by EM simulation. All parasitic resonances, such as cavity resonance or slot loop resonance that can occur in the embedding package were analyzed using an EM simulator and circuit model. Each resonance is removed by the appropriate positioning of via holes. As a result, the measured insertion loss of the CTC interconnection is 0.2 dB at 100 GHz without degradation of return loss and the return loss is more than 18 dB at broadband (0-100 GHz). To demonstrate the technology, an embedded IC module combining an 8x frequency multiplier and the drive amplifier was realized using the proposed process. The measured peak conversion gain was improved from 2.08 to 4.6 dB at 84 GHz in comparison to the typical embedded-IC module.Keywords
Funding Information
- Agency for Defense Development
This publication has 16 references indexed in Scilit:
- Industrial mmWave Radar Sensor in Embedded Wafer-Level BGA Packaging TechnologyIEEE Sensors Journal, 2016
- Design and experimental evaluation of compensated bondwire interconnects above 100 GHzInternational Journal of Microwave and Wireless Technologies, 2015
- Packaging a $W$-Band Integrated Module With an Optimized Flip-Chip Interconnect on an Organic SubstrateIEEE Transactions on Microwave Theory and Techniques, 2013
- 77-GHz Multi-Channel Radar Transceiver With Antenna in PackageIEEE Transactions on Antennas and Propagation, 2013
- Embedded IC module package using silicon substrate2012
- 122-GHz chip-to-antenna wire bond interconnect with high repeatability2012
- Flip-Chip-Assembled $W$-Band CMOS Chip Modules on Ceramic Integrated Passive Device With Transition Compensation for Millimeter-Wave System-in-Package IntegrationIEEE Transactions on Microwave Theory and Techniques, 2012
- Design and measurement of matched wire bond and flip chip interconnects for D-band system-in-package applications2011
- Cavity-resonance dampeningIEEE Microwave Magazine, 2005
- Theory and measurements of flip-chip interconnects for frequencies up to 100 GHzIEEE Transactions on Microwave Theory and Techniques, 2001