Determination of melt processing conditions for high performance amorphous thermoplastics for large format additive manufacturing
Authors:
- Christine AjinjeruCAChristine Ajinjeru
- Vidya KishoreVidya Kishore
- Peng LiuPLPeng Liu
- John LindahlJLJohn Lindahl
- Ahmed Arabi HassenAHAhmed Arabi Hassen
- Vlastimil KuncVKVlastimil Kunc
- Brian PostBPBrian Post
- Lonnie LoveLLLonnie Love
- Chad DutyChad Duty
- 1 May 2018
- journal article
- research article
- Published by Elsevier in Additive Manufacturing
- Vol. 21, 125-132
Abstract
No abstract availableKeywords
Funding Information
- Office of Energy Efficiency and Renewable Energy
- U.S. Department of Energy
- Advanced Manufacturing Office (DE-AC05-00OR22725)
This publication has 32 references indexed in Scilit:
- Use of Fused Deposition Modeling of Polyphenylsulfone for Centrifugal Casting of Polyurethane: Material, Surface, and Process ConsiderationsJournal of Manufacturing Science and Engineering, 2011
- Rheological Properties of a Particulate-Filled Polymeric Composite through Fused Deposition ProcessMaterials Science Forum, 2010
- Measurement of anisotropic compressive strength of rapid prototyping partsJournal of Materials Processing Technology, 2007
- Liquefier Dynamics in Fused DepositionJournal of Manufacturing Science and Engineering, 2004
- Effects of extrusion conditions on rheological behavior of acrylonitrile–butadiene–styrene terpolymer meltJournal of Applied Polymer Science, 2002
- Shear viscosity of rubber modified thermoplastics: Dynamically vulcanized thermoplastic elastomers and ABS resins at very low stressPolymer Engineering & Science, 1998
- Rheological properties and fiber orientations of short fiber-reinforced plasticsJournal of Rheology, 1997
- Viscoelastic properties of acrylonitrile‐butadiene‐styrene (ABS) polymers in the molten statePolymer Engineering & Science, 1995
- Rheology of suspensions of rodlike particlesJournal of Statistical Physics, 1991
- Flow visualization of fiber suspensionsPolymer Engineering & Science, 1978