A novel evaporative cooling tower constructed from an inflatable fabric duct
Authors:
- 8 May 2018
- journal article
- research article
- Published by Taylor & Francis in Science and Technology for the Built Environment
- Vol. 24 (8) , 908-918
Abstract
This paper describes a prototype of a novel vertical cooling tower constructed from an inflatable fabric duct that incorporated a water spray nozzle mounted at the top. The device was constructed using two concentric impermeable fabric tubes sealed at either end. It was inflated using a small pressurization fan located at the tower base. A numerical performance model was developed to estimate the downstream conditions of the evaporative cooling tower, and the length necessary for complete evaporation. To test the predictive capability the model of the evaporative cooling tower, experiments were performed under different ambient conditions. The prototype tower did exhibit downdraft cooling. However, the ambient conditions under which the validation measurements were performed were not conducive to achieving a moist air flow that could be measured accurately, and further investigation is recommended.Keywords
This publication has 14 references indexed in Scilit:
- The study on the evaporation cooling efficiency and effectiveness of cooling tower of film typeEnergy Conversion and Management, 2011
- A multi-stage down-draft evaporative cool tower for semi-enclosed spaces: Experiments with a water spraying systemSolar Energy, 2008
- A multi-stage down-draft evaporative cool tower for semi-enclosed spaces: Aerodynamic performanceSolar Energy, 2008
- Modeling of water spray evaporation: Application to passive cooling of buildingsSolar Energy, 2006
- Building Thermal Performance Simulation with Direct Evaporative Cooling by Water Spray VaporizationHVAC&R Research, 2006
- Refining the use of evaporation in an experimental down-draft cool towerEnergy and Buildings, 1996
- Solar chimney for enhanced stack ventilationBuilding and Environment, 1993
- Evaluation of pressure coefficients and estimation of air flow rates in buildings employing wind towersSolar Energy, 1986
- An improved design of wind towers for natural ventilation and passive coolingSolar Energy, 1985
- Simple and Explicit Formulas for the Friction Factor in Turbulent Pipe FlowJournal of Fluids Engineering, 1983