Time-dependent frictional properties of granular materials used in analogue modelling: implications for mimicking fault healing during reactivation and inversion
Open Access
- 10 March 2023
- journal article
- research article
- Published by Copernicus GmbH in Solid Earth
- Vol. 14 (3) , 311-331
Abstract
Analogue models are often used to model long-term geological processes such as mountain building or basin inversion. Most of these models use granular materials such as sand or glass beads to simulate the brittle behaviour of the crust. In granular material, deformation is localised in shear bands, which act as an analogue to natural fault zones and detachments. Shear bands, also known as faults, are permanent anomalies in the granular package and are often reactivated during a test run. This is due to their lower strength compared to the undeformed material. When the fault movement stops, time-dependent healing immediately begins to increase the strength of the fault. Faults that have been inactive for a long time therefore have a higher strength than younger faults. This time-dependent healing, also called time consolidation, can therefore affect the structure of an analogue model as the strength of the fault changes over time. Time consolidation is a well-known mechanism in granular mechanics, but it is poorly described for analogue materials and on the timescales of typical analogue models. In this study, we estimate the healing rate of different analogue materials and evaluate the impact on the reactivation potential of analogue faults. We find that healing rates are generally less than 3 % per 10-fold increase in holding time, which is comparable to natural fault zones. We qualitatively compare the frictional properties of the materials with grain characteristics and find a weak correlation of healing rates with sphericity and friction with an average quality score. Accordingly, in models where there are predefined faults or reactivation is forced by blocks, the stability range of the fault angles that can be reactivated can decrease by up to 7∘ over the duration of 12 h. The stress required to reactivate an existing fault can double in the same time, which can favour the development of new faults. In a basin inversion scenario, normal faults cannot be inverted because of the strong misorientation, so time consolidation plays little additional role for such models.Keywords
All Related Versions
Funding Information
- Deutsche Forschungsgemeinschaft (235221301)
This publication has 68 references indexed in Scilit:
- Numerical investigation of particle shape and particle friction on limiting bulk friction in direct shear tests and comparison with experimentsPowder Technology, 2011
- Oblique half-graben inversion of the Mesozoic Neuquén Rift in the Malargüe Fold and Thrust Belt, Mendoza, Argentina: New insights from analogue modelsJournal of Structural Geology, 2008
- Normal fault inversion by orthogonal compression: Sandbox experiments with weak faultsJournal of Structural Geology, 2008
- Mechanical behaviour of granular materials used in analogue modelling: insights from grain characterisation, ring-shear tests and analogue experimentsJournal of Structural Geology, 2006
- The impact of analogue material properties on the geometry, kinematics, and dynamics of convergent sand wedgesJournal of Structural Geology, 2003
- Influence of grain characteristics on the friction of granular shear zonesJournal of Geophysical Research, 2002
- Are polymers suitable rock analogs?Tectonophysics, 2002
- Modelling hanging wall accommodation above rigid thrust rampsJournal of Structural Geology, 2000
- Laboratory study of fault healing and lithification in simulated fault gouge under hydrothermal conditionsTectonophysics, 1997
- Flow behaviour and physical chemistry of bouncing putties and related polymers in view of tectonic laboratory applicationsTectonophysics, 1986