Experiments and Computations on Large Tip Clearance Effects in a Linear Cascade
Authors:
- 20 January 2010
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 132 (2) , 021018
Abstract
Large tip clearances typically in the region of 6% exist in the high pressure (HP) stages of compressors of industrial gas turbines. Due to the relatively short annulus height and significant blockage, the tip clearance flow accounts for the largest proportion of loss in the HP. Therefore increasing the understanding of such flows will allow for improvements in design of such compressors, increasing efficiency, stability, and the operating range. Experimental and computational techniques have been used to increase the physical understanding of the tip clearance flows through varying clearances in a linear cascade of controlled-diffusion blades. This paper shows two unexpected results. First the loss does not increase with clearances greater than 4% and second there is an increase in blade loading toward the tip above 2% clearance. It appears that the loss production mechanisms of the pressure driven tip clearance jet do not increase as the clearance is increased to large values. The increase in blade force is attributed to the effect of the strong tip clearance vortex, which does not move across the blade passage to the pressure surface, as is often observed for high stagger blading. These results may be significant for the design of HP compressors for industrial gas turbines.Keywords
This publication has 12 references indexed in Scilit:
- Interaction of Tip Clearance Flow and Three-Dimensional Separations in Axial Compressors2006
- A Study of Large Tip Clearance Flows in an Axial Compressor Blade Row2006
- Prediction of Low Speed Compressor Rotor Flowfields With Large Tip Clearances2003
- Three-dimensional unsteady Navier—Stokes analysis of stator—rotor interaction in axial-flow turbinesProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2000
- Recommendations for Achieving Accurate Numerical Simulation of Tip Clearance Flows in Transonic Compressor RotorsJournal of Turbomachinery, 1999
- Measurements of the Tip-Leakage Flow in a Turbine Cascade With Large Clearances1995
- Tip Leakage Flow in Axial CompressorsJournal of Turbomachinery, 1991
- The Use of Optimization Techniques to Design-Controlled Diffusion Compressor BladingJournal of Engineering for Power, 1983
- A review of turbomachinery tip gap effectsInternational Journal of Heat and Fluid Flow, 1982
- Casing Wall Boundary-Layer Development Through an Isolated Compressor RotorJournal of Engineering for Power, 1982