Ductile-brittle transition at edge cracks (001)[110] in BCC iron under different loading rates in mode I: a 3D atomistic study
Open Access
- 1 March 2022
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 9 (3) , 036508
Abstract
3D atomistic simulations via molecular dynamics (MD) at temperature of 0 K and 295 K (22 °C) with a high quasi-static loading rate dP/dt of 2.92 kN s−1 show that cleavage fracture is supported by surface emission of oblique dislocations 11 1 ¯ 011 and by their subsequent cross slip to {112} planes, which increases separation of the (001) cleavage planes inside the crystal. Under the slower loading rate by a factor 5, the crack growth is hindered by twin generation on oblique planes {112} and the fracture is ductile. The MD results explain the contribution of the crack itself to the ductile-brittle transition observed in our fracture experiments on Fe-3wt%Si single crystals of the same orientation and geometry, loaded at the same rates dP/dt as in MD. The loading rates are equivalent to the cross head speed of 5 mm min−1 and 1 mm min−1 used in the experiment. The MD results also agree with the stress analysis performed by the anisotropic LFM and comply with experimental observations.Keywords
Funding Information
- Grantová Agentura České Republiky (GA19-03282S)
- Technology Agency of the Czech Republic (TK01030108)
- European Regional Development Fund (No.CZ.02.1.01/0.0/0.0/15_003/0000493)
This publication has 32 references indexed in Scilit:
- Crack Orientation versus Ductile-Brittle Behavior in 3D Atomistic SimulationsMaterials Science Forum, 2007
- Influence of crack orientation on the ductile–brittle behavior in Fe–3 wt.% Si single crystalsMaterials Characterization, 2007
- Reconciliation of continuum and atomistic models for the ductile versus brittle response of ironModelling and Simulation in Materials Science and Engineering, 2007
- Residual stress in Fe–Cu alloys at 0 and 600 KComputational Materials Science, 2002
- Stress calculations on the atomistic levelModelling and Simulation in Materials Science and Engineering, 2001
- Atomistic simulation of stacking fault formation in bcc ironModelling and Simulation in Materials Science and Engineering, 1999
- Dynamic overshoot in -iron by atomistic simulationsModelling and Simulation in Materials Science and Engineering, 1998
- Computer simulation of point defect properties in dilute Fe—Cu alloy using a many-body interatomic potentialPhilosophical Magazine A, 1997
- COMPENDIUM OF T‐STRESS SOLUTIONS FOR TWO AND THREE DIMENSIONAL CRACKED GEOMETRIESFatigue & Fracture of Engineering Materials & Structures, 1995
- Multilayer stacking faults and twins on {211} planes in B.C.C. metalsScripta Metallurgica, 1970