Natural Amplification of Soft Defects Signatures in Cables Using Binary Time Domain Reflectometry
- 2 December 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 21 (2) , 937-944
Abstract
In our digital world, energy and data transmission play a major role and often rely on electrical wires. Some of these wires are used in harsh or aggressive environments and may be subject to defects. Security and preventive maintenance require tools to detect and precisely locate such defects. This paper details the Binary Time Domain Reflectometry (BTDR) method, presented earlier, which does not rely on the use of expensive and complex digital to analog and analog to digital conversion components. We explain the role of additive white noise and of the use of the time derivative for the improvement of its performances. The study focuses on BTDR’s natural capacity of magnifying soft defects’ peaks on the reflectogram. The method takes advantage of phase opposition to cancel the contribution of the extremities of the line under test and saturate the amplitudes of the remaining peaks. This can only be achieved if these contributions are equal or very close to each other. A balancing device is added at the cable’s interface to meet this requirement. This low complexity additional system, made of two controlable digital potentiometers, is driven by the programmable logic digital system at the heart of the reflectometer. Direct magnification of very low amplitude peaks of incipient defects is obtained without any data post-processing. The amplification performance depends on the adjustment accuracy of the potentiometers and the hysteresis level of the comparator used to replace the converters.Keywords
This publication has 16 references indexed in Scilit:
- Equivalent Circuit Model of Soft Shield Defects in Coaxial Cables Using Numerical ModelingIEEE Transactions on Electromagnetic Compatibility, 2016
- Chaos Time Domain Reflectometry for Online Defect Detection in Noisy Wired NetworksIEEE Sensors Journal, 2016
- Soft defects localization by signature magnification with selective windowing2015
- Self-adaptive correlation method for soft defect detection in cable by reflectometry2014
- Embedded wire diagnosis sensor for intermittent fault location2014
- On-line diagnosis using Orthogonal Multi-Tone Time Domain Reflectometry in a lossy cable2013
- TIME REVERSAL FOR SOFT FAULTS DIAGNOSIS IN WIRE NETWORKSProgress In Electromagnetics Research M, 2013
- A Distributed Diagnosis Strategy using Bayesian Network for Complex Wiring NetworksIFAC Proceedings Volumes, 2012
- Down to the wire [aircraft wiring]IEEE Spectrum, 2001
- Digital simulation of fault location on EHV lines using wideband spread spectrum techniquesIEE Proceedings - Generation, Transmission and Distribution, 1995