Microstructure, Compressive Properties and Oxidation Behaviors of the Nb-Si-Ti-Cr-Al-Ta-Hf Alloy with Minor Holmium Addition
- 11 April 2024
- journal article
- research article
- Published by Polish Academy of Sciences Chancellery in Archives of Metallurgy and Materials
- Vol. 69 (1) , 181-187
Abstract
In the present research, the Nb-Si-Ti-Cr-Al-Ta-Hf alloys with different Ho addition were prepared. Their microstructure, compressive properties and oxidation behaviors were investigated preliminarily. The results exhibit that the Nb-Si-Ti-Cr-Al-Ta-Hf alloy has coarse microstructure which is mainly composed of Nb solid solution, Nb5Si3 and Ti5Si3 phases. The minor Ho addition could refine the microstructure and suppress the precipitation of Ti5Si3 phase. Moreover, the Ho addition also leads to the formation of Ho2Hf2O7, which prefers to precipitate along the Nbss/Nb5Si3 phase interface. Compared with the Nb-Si-Ti-Cr-Al-Ta-Hf alloy, the minor Ho addition improves the room-temperature and high-temperature compressive properties of the alloy. Its room-temperature compressive strength and ductility obtain the maximum value of 1825 MPa and 16.5% when the Ho content is 0.1 at.%. Moreover, its best compressive strength at 873 K, 1273 K and 1473 K is 1495 MPa, 765 MPa and 380 MPa, respectively, when the Ho addition is 0.1 at.%. The oxidation behavior of the Nb-Si-Ti-Cr-Al-Ta-Hf alloy is diversified with the Ho addition. The oxidation rate of the alloy with 0.1 at.% Ho addition is the lowest while the alloy with 0.2 at.% Ho addition is the highest. Therefore, the 0.1 at.% Ho would be the appropriate content for the Nb-Si-Ti-Cr-Al-Ta-Hf alloy.Keywords
This publication has 28 references indexed in Scilit:
- Improvement of “pest” oxidation resistance of Nb-Mo-W-Zr solid- solution alloy at 800 °C by gas nitridationCorrosion Science, 2021
- Microalloying effects of Ho on microstructure evolution and high temperature properties of Ti46Al4Nb1Mo alloyIntermetallics, 2020
- Preparation of single-phase Ti2AlN coating by magnetron sputtering with cost-efficient hot-pressed Ti-Al-N targetsCeramics International, 2018
- Alloying effects on the microstructure and properties of Nb–Si based ultrahigh temperature alloysIntermetallics, 2016
- Improvement of compressive strength and ductility in NiAl–Cr(Nb)/Dy alloy by rapid solidification and HIP treatmentIntermetallics, 2012
- Study of the role of Al, Cr and Ti additions in the microstructure of Nb–18Si–5Hf base alloysIntermetallics, 2010
- Microstructures and mechanical properties of cast Nb–Ti–Si–Zr alloysIntermetallics, 2008
- High-temperature strength and deformation of γ/γ′ two-phase Co–Al–W-base alloysActa Materialia, 2008
- Microstructural and mechanical characterization of Nb-based in situ composites from Nb–Si–Ti ternary systemActa Materialia, 2007
- Effects of alloying elements on phase stability in Nb–Si system intermetallics materialsIntermetallics, 2007