System modelling of a lateral force microscope
- 9 October 2008
- journal article
- Published by IOP Publishing in Nanotechnology
- Vol. 19 (45) , 455707
Abstract
To quantitatively analyse lateral force microscope measurements one needs to develop a model able to relate the photodiode signal to the force acting on the tip apex. In this paper we focus on the modelling of the interaction between the cantilever and the optical chain. The laser beam is discretized by a set of rays which propagates in the system. The analytical equation of a single ray's position on the optical sensor is presented as a function of the reflection's state on top of the cantilever. We use a finite element analysis on the cantilever to connect the optical model with the force acting on the tip apex. A first-order approximation of the constitutive equations are derived along with a definition of the system's crosstalk. Finally, the model is used to analytically simulate the 'wedge method' in the presence of crosstalk in 2D. The analysis shows how the torsion loop and torsion offset signals are affected by the crosstalk.Keywords
This publication has 9 references indexed in Scilit:
- Cross-talk correction in atomic force microscopyReview of Scientific Instruments, 2007
- Lateral force calibration of an atomic force microscope with a diamagnetic levitation spring systemReview of Scientific Instruments, 2006
- Finite element analysis of V‐shaped cantilevers for atomic force microscopy under normal and lateral force loadsSurface and Interface Analysis, 2006
- An improved wedge calibration method for lateral force in atomic force microscopyReview of Scientific Instruments, 2003
- Crosstalk problems in scanning-by-probe atomic force microscopyReview of Scientific Instruments, 2003
- Cross talk between friction and height signals in atomic force microscopyReview of Scientific Instruments, 2002
- Nanoscale tribophysics and tribomechanicsWear, 1999
- Calibration of frictional forces in atomic force microscopyReview of Scientific Instruments, 1996
- Calibration procedures for frictional measurements with a lateral force microscopeWear, 1996