Finite element analysis of V‐shaped cantilevers for atomic force microscopy under normal and lateral force loads
Authors:
- 24 April 2006
- journal article
- research article
- Published by Wiley in Surface and Interface Analysis
- Vol. 38 (6) , 1090-1095
Abstract
For the quantitative investigation of surface properties such as elasticity, friction and wear by atomic force microscopy (AFM), a quantitative determination of the forces acting on the probe during its motion along the sample surface is essential. In this article, a fully parameterized finite element model for V‐shaped cantilevers is presented and the three‐dimensional mechanical deformations of the AFM cantilever are investigated. Force constants and detection angles for tip displacements in the three spatial directions are calculated for widely used cantilevers. The limits of linearity according to Hook's law are studied. It is found that the AFM contact cantilevers investigated here show a linear bending behavior for tip displacements within a range below approx. 10 nm in lateral directions and 100 nm in the normal direction. Displacements within this range are typical for many AFM applications including force modulation techniques. For higher loads as used e.g. for surface modification, a significant deviation from linear behavior is observed. Copyright © 2006 John Wiley & Sons, Ltd.Keywords
This publication has 20 references indexed in Scilit:
- Normal and torsional spring constants of atomic force microscope cantileversReview of Scientific Instruments, 2004
- Susceptibility of atomic force microscope cantilevers to lateral forcesReview of Scientific Instruments, 2003
- Adhesion imaging of carbon‐fibre‐reinforced materials in the pulsed force mode of the atomic force microscopeSurface and Interface Analysis, 2002
- Spring constants of composite ceramic/gold cantilevers for scanning probe microscopyThin Solid Films, 1999
- Determination of the spring constants of probes for force microscopy/spectroscopyNanotechnology, 1996
- Parallel beam approximation for V-shaped atomic force microscope cantileversReview of Scientific Instruments, 1995
- Lateral, normal, and longitudinal spring constants of atomic force microscopy cantileversReview of Scientific Instruments, 1994
- A nondestructive method for determining the spring constant of cantilevers for scanning force microscopyReview of Scientific Instruments, 1993
- Scan speed limit in atomic force microscopyJournal of Microscopy, 1993
- Using force modulation to image surface elasticities with the atomic force microscopeNanotechnology, 1991