A new reduced model of scavenging to optimize cylinder design
- 12 May 2016
- journal article
- research article
- Published by SAGE Publications in SIMULATION
- Vol. 92 (6) , 507-520
Abstract
This paper presents the development of a new scavenging model to optimize cylinder design. The developed model explicitly integrates some of the cylinder’s design and environmental variables to describe flows during the scavenging process. Then, based on the reduced model, an optimization phase was carried out in order to determine the optimal values of cylinder variables. From computational fluid dynamics (CFD) models to optimal cylinder design, all method steps used are described in this paper. Adaptable to any type of engine, here it is applied to the particular two-stroke diesel engine with ports only. In order to fully understand fluid flow, the methodology integrates a number of CFD calculations with different cylinder configurations to provide data. The CFD results are used as neural network outputs during the training phase, whereas the cylinder variables plus the crankshaft angle are the inputs. The trained network provides the analytical reduced model for gas composition transiting through ports, which characterize the scavenging process. Thanks to these, genetic algorithms are run to define the most suitable values of cylinder variables in order to improve scavenging. The entire process for establishing the reduced model and the optimal design of the chamber is presented in this paper.Keywords
This publication has 12 references indexed in Scilit:
- Evaluation analysis of scavenging process of two-stroke marine diesel engine by experiment and simulationJournal of Thermal Science and Technology, 2014
- Computational Fluid Dynamics Analysis of the Scavenging Process in the MAN B&W 7S50MC Two-Stroke Marine Diesel EngineJournal of Ship Research, 2012
- High swirl-inducing piston bowls in small diesel engines for emission reductionApplied Energy, 2011
- Virtual design of a novel two-stroke high-speed direct-injection diesel engineInternational Journal of Engine Research, 2009
- Development of an Efficient 3–D CFD Software to Simulate and Visualize the Scavenging of a Two-Stroke EngineArchives of Computational Methods in Engineering, 2007
- Scavenging Measurements in a Direct-Injection Two-Stroke EngineSAE International Journal of Advances and Current Practices in Mobility, 2003
- Design and Simulation of Two Stroke Engines1996
- Learning representations by back-propagating errorsNature, 1986
- A method for obtaining a quantitative assessment of the influence of charging efficiency on two-stroke engine performanceInternational Journal of Mechanical Sciences, 1969
- THE CHARGING OF TWO‐CYCLE INTERNAL‐COMBUSTION ENGINES*Journal of the American Society for Naval Engineers, 1914