Vortex Tube Heat Booster to Improve Performance of Heat Driven Cooling Cycles for Automotive Applications
Authors:
- 5 April 2016
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Increasing energy costs justify research on how to improve utilization of low-grade energy that is abundantly available as waste heat from many thermodynamic processes such as internal combustion engine cycles. One option is to directly generate cooling through absorption/adsorption or vapor jet ejector cycles. As in the case of power generation cycles, cooling cycle efficiencies would increase if the heat input were available at higher temperature. This paper assesses the feasibility of a novel idea that uses a vortex tube to increase the available temperature levels of low-grade heat sources. The desired temperature increase is achieved by sending a stream of vapor that was heated by the waste heat source through a vortex tube, which further elevates the temperature used in a heat driven ejector cooling cycle. Simulation results show that COP can be increased by 40% with the use of the vortex tube heat booster when the cycle is operating with low entrainment ratio at conditions where baseline performance and COP are low.Keywords
This publication has 11 references indexed in Scilit:
- The influence of working gas characteristics on energy separation of vortex tubeApplied Thermal Engineering, 2013
- A review on design criteria for vortex tubesHeat and Mass Transfer, 2008
- Large eddy simulations of the flow field and temperature separation in the Ranque–Hilsch vortex tubeInternational Journal of Heat and Mass Transfer, 2007
- Comparison of CFD analysis to empirical data in a commercial vortex tubeInternational Journal of Refrigeration, 2006
- Ejectors: applications in refrigeration technologyRenewable and Sustainable Energy Reviews, 2004
- A SOLAR EJECTOR COOLING SYSTEM USING REFRIGERANT R141bSolar Energy, 1998
- Ejector Performance Characteristics and Design Analysis of Jet Refrigeration SystemJournal of Engineering for Gas Turbines and Power, 1985
- An investigation of energy separation in a vortex tubeInternational Journal of Heat and Mass Transfer, 1983
- Experimental Study of Two-Phase Propane Expanded through the Ranque-Hilsch TubeJournal of Heat Transfer, 1979
- The Use of the Expansion of Gases in a Centrifugal Field as Cooling ProcessReview of Scientific Instruments, 1947