Machining of microholes in Ti-6Al-4V by hybrid micro electrical discharge machining to improve process parameters and flushing properties
Open Access
- 30 June 2020
- journal article
- research article
- Published by Polish Academy of Sciences Chancellery in Bulletin Of The Polish Academy Of Sciences-Technical Sciences
- Vol. 68 (3) , 565-573
Abstract
In this research work, the Ti-6Al-4V material was used for the investigation of machining parameters by means of hybrid micro electrical discharge machining to improve the machining process and reduce the negative effects of debris accumulation in the drilled hole. L9 orthogonal array was used in the Taguchi based grey relational analysis to optimize the parameters such as material removal rate and diametrical accuracy of the machining process for Ti-6Al-4V. This work encompasses the design, development, and calibration of the work piece vibration platform and experimental analysis of the process parameters by means of the hybrid micro electrical discharge machining process. The maximum material removal rate and minimum surface roughness was observed at the current value of 2.5 A, pulse on time is 2 µs and pulse off time is 14.5 µs. The maximum material removal rate was observed for the increase in pulse on time with 14.4 µs and 4 A current level. The diametrical accuracy of the microholes was increased while increasing the pulse off time and decreasing the pulse on time. The fluid flow simulation has been conducted to find out the pressure drop and to know the velocity of the flow inside the hole for the effective flushing of the debris during machining.Keywords
This publication has 11 references indexed in Scilit:
- Application of response surface methodology and fuzzy logic based system for determining metal cutting temperatureBulletin Of The Polish Academy Of Sciences-Technical Sciences, 2016
- Study on Influence of Electrode Material on Hole Drilling in Micro-EDMProcedia CIRP, 2016
- Study of Vibration Assisted Inclined feed Micro-EDM DrillingProcedia CIRP, 2016
- Precision machining of micro tool electrodes in micro EDM for drilling array micro holesPrecision Engineering, 2015
- Workpiece and electrode influence on micro-EDM drilling performancePrecision Engineering, 2014
- Experimental study on micro EDM-drilling of Ti6Al4V using helical electrodePrecision Engineering, 2014
- EDM drilling of ultra-high aspect ratio micro holes with insulated toolsCIRP Annals, 2013
- Modeling and simulation of electrical discharge machiningProcedia CIRP, 2012
- Vibration Assisted EDM of Small-hole Using Voice Coil MotorProcedia CIRP, 2012
- A Study on Process Parameters of Ultrasonic Assisted Micro EDM Based on Taguchi MethodJournal of Materials Engineering and Performance, 2007