Enhanced mechanical properties of Sr-modified Al–Mg–Si alloy by thermo-mechanical treatment
Authors:
- 16 December 2024
- journal article
- research article
- Published by Walter de Gruyter GmbH in Materials Testing
- Vol. 67 (1) , 136-146
Abstract
In this study, the effect of thermomechanical treatments applied to strontium-modified A360 alloy on the microstructure and mechanical properties of the alloy was investigated. Optical microscopy, XRD, and SEM were employed to examine the microstructural properties, while tensile and hardness tests were conducted on the samples to evaluate the mechanical properties. It was observed that the strength values increased as the deformation amount increased, and subsequently, optimum conditions (tensile strength and ductility) were determined after the subsequent aging treatment. Following cold deformation, dendritic structure shifted towards the direction of deformation along with the eutectic silicon structure. After aging, it was found that the dendritic structure transformed into equiaxed grains at certain temperature. The highest tensile strength of 383 MPa was achieved in the sample with a deformation amount of 70 %. In this case, the ductility value was 2.85 %. Subsequently, the optimum conditions after aging were determined as 160 °C & 4 h, resulting in a tensile strength of 341 MPa and ductility of 3.62 %.Keywords
Funding Information
- Tekirdag Namik Kemal University Scientific Research Unit (Grant number: NKUBAP.06.DR.21.310.)
This publication has 24 references indexed in Scilit:
- Influence of thermomechanical processing on coarse particles, grain structure, and mechanical properties of Al–Cu alloy ringsJournal of Materials Research and Technology, 2022
- X-ray diffraction analysis by Williamson-Hall, Halder-Wagner and size-strain plot methods of CdSe nanoparticles- a comparative studyMaterials Chemistry and Physics, 2020
- Effects of heat treatment and addition of small amounts of Cu and Mg on the microstructure and mechanical properties of Al-Si-Cu and Al-Si-Mg cast alloysJournal of Alloys and Compounds, 2019
- Rotating and bending fatigue behavior of A356 aluminum alloy: Effects of strontium addition and T6 heat treatmentInternational Journal of Fatigue, 2018
- Transformation of cast A356 ingots to wrought sheets with enhanced mechanical and tribological properties by different thermo-mechanical processing routesMaterials & Design, 2016
- Effects of in-situ γ-Al2O3 particles and heat treatment on the microstructure and mechanical properties of A356 aluminium alloyJournal of Alloys and Compounds, 2015
- Effect of thermo mechanical treatments and aging parameters on mechanical properties of Al–Mg–Si alloy containing 3wt.% LiMaterials & Design (1980-2015), 2014
- Effects of Sr on the microstructure and mechanical properties of in situ TiB2 reinforced A356 compositeMaterials & Design (1980-2015), 2014
- An investigation to the effect of deformation-heat treatment cycle on the eutectic morphology and mechanical properties of a Thixocast A356 alloyMaterials Characterization, 2009
- Effect of post equal-channel-angular-pressing aging on the modified 7075 Al alloy containing ScJournal of Alloys and Compounds, 2008