Possibility of Utilization of Gate Geometry to Modify the Mechanical and Structural Properties of Castings on the Al-Si Basis
Open Access
Abstract
The mechanical properties of die castings correlate with the inner structure of a casting, distribution of the eutectic phases, and with the content and distribution of porous cavities in the casting volume. This submitted paper deals with the issue of the possibility to influence the basic parameters affecting the quality of castings through structural modifications of the gating system. The structural parameter under assessment is the gate height. In the case of the diverse height of the gate, five sets of castings were produced. The individual sets of castings were subjected to examination of selected mechanical properties, i.e., of permanent deformation and surface hardness. At the same time, the individual sets of castings were subjected to metallographic examination of the eutectic structure of the casting. It was proved that the gate height influences the aforementioned properties of the castings and significantly affects the ratio of the eutectic phases in the volume of the casting. The conclusion describes the mutual correlation between the gate structure, the mechanical properties of the casting, and its structural composition.Keywords
This publication has 20 references indexed in Scilit:
- The Effect of Water Mist Cooling of Casting Die on the Solidification, Microstructure and Properties of AlSi20 AlloyArchives of Metallurgy and Materials, 2017
- The Effect of a Thin-Wall Casting Mould Cavity Filling Conditions on the Casting Surface QualityArchives of Foundry Engineering, 2016
- Development and application of inverse heat transfer model between liquid metal and shot sleeve in high pressure die casting process under non-shooting conditionChina Foundry, 2016
- Pressing Speed, Specific Pressure and Mechanical Properties of Aluminium CastArchives of Foundry Engineering, 2016
- Determination of Microstructure, Mechanical, Electrical and Thermal Properties of The Directionally Solidified Al-Si-Co Ternary AlloyMaterials Research, 2016
- Effects of Solidification Behavior during Filling on Surface Defects of Aluminum Alloy Die CastingMATERIALS TRANSACTIONS, 2013
- Mechanical Properties of Al-Si-Mg Alloy Castings as a Function of Structure Refinement and Porosity FractionArchives of Foundry Engineering, 2012
- The Influence of Material of Mould and Modification on the Structure of Alsi11 AlloyArchives of Foundry Engineering, 2012
- Compression Behavior of Entrapped Gas in High Pressure DiecastingMATERIALS TRANSACTIONS, 2012
- The aluminum–silicon eutectic reaction: mechanisms and crystallographyJournal of Light Metals, 2001