The Effect of Water Mist Cooling of Casting Die on the Solidification, Microstructure and Properties of AlSi20 Alloy
Open Access
- 1 March 2017
- journal article
- Published by Walter de Gruyter GmbH in Archives of Metallurgy and Materials
- Vol. 62 (1) , 187-194
Abstract
Unmodified AlSi20 alloy were casted at the research station, allowing for sequential multipoint cooling using a dedicated computer- controlled program. This method allows for the formation of the microstructure of hypereutectic AlSi20 alloy and also increases hardness. Primary silicon dendrites were found in the microstructure of cooled samples. Based on these dendrites, the formation of primary silicon particles is explained. Cooling of casting die with a water mist stream causes changes in solidification, which leads to expansion of the boundary layer with columnar crystals and shrinkage of the core zone with equiaxed crystals. It also causes more regular hardness distribution around pre-eutectic Si crystals, which can lead to tensile strength and machinability improvement.Keywords
This publication has 12 references indexed in Scilit:
- Effect of Water Mist Cooling on Microstructure of Hypereutectic Al-Si AlloyArchives of Foundry Engineering, 2014
- Computer Control the Cooling Process in Permanent Mold Casting of Al-Si AlloyArchives of Metallurgy and Materials, 2013
- Water-Air Spray Cooling of Extruded Profiles: Process Integrated Heat Treatment of the Alloy EN AW-6082Journal of Materials Engineering and Performance, 2013
- The influence of Si and V on the kinetics of phase transformation and microstructure of rapidly solidified Al-Fe-Zr alloysJournal of Mining and Metallurgy, Section B: Metallurgy, 2013
- A Cu-Cr alloy with nano and microscale Cr particles produced in a water-cooled copper moldInternational Journal of Minerals, Metallurgy and Materials, 2010
- Dendritic Growth in an Aluminum-Silicon AlloyJournal of Materials Engineering and Performance, 2007
- THERMAL ANALYSIS STUDY OF THE EFFECT OF THE COOLING RATE ON THE MICROSTRUCTURE AND SOLIDIFICATION PARAMETERS OF 319 ALUMINUM ALLOYCanadian Metallurgical Quarterly, 2005
- A simple inexpensive technique for enhancing density and mechanical properties of AlSi alloysJournal of Materials Processing Technology, 2004
- Influence of alloying elements on the thermal analysis results of Al–Si cast alloysJournal of Light Metals, 2002
- Some observations on dendritic arm spacing in Al-Si-Mg and Al-Cu alloy chill castingsJournal of Materials Science, 1986