Effect of different grain sizes and textures on the corrosion behaviour of aluminum alloy AA6082
- 13 July 2011
- journal article
- research article
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 42 (7) , 606-611
Abstract
The fabrication and processing of aluminum alloys can result in the formation of different grain sizes and textures within the material. The effects of these differences on the corrosion behaviour of the commercially available alloy AA6082 have been investigated. The results of the macro‐ and microelectrochemical investigations have been compared with each other and with the resulting corrosion appearance. The observed corrosion damage is not always consistent with the measured corrosion and pitting potential. In the finer‐grained part, with a strongly preferred orientation of (002) planes parallel to the sample surface, less corrosion damage could be observed than in the coarser‐grained part. However, microelectrochemical measurements show a slightly lower pitting potential in the finer‐grained part, so that pitting is likely to start earlier in this area.Keywords
This publication has 8 references indexed in Scilit:
- Gradation Rolling – Technology for graded ultrafine‐grained materialsMaterialwissenschaft und Werkstofftechnik, 2010
- Herstellung, Mikrostruktur und Korrosionsverhalten der konventionellen und ultrafeinkörnigen Legierung EN AW-6082Materialwissenschaft und Werkstofftechnik, 2008
- Corrosion Characteristics of an Ultrafine-Grained Al-Mg-Si Alloy (AA6082)Materials Science Forum, 2008
- Effects of severe plastic deformation on the corrosion behavior of aluminum alloysJournal of Solid State Electrochemistry, 2008
- Effect of α-Al/Al3Ni microstructure on the corrosion behaviour of Al–5.4wt% Ni alloy fabricated by equal-channel angular pressingCorrosion Science, 2007
- Corrosion Behavior of Al-7wt% Si-1.5wt% Cu Severely Deformed by Equal-Channel Angular PressingMaterials Science Forum, 2007
- Influence of Microstructure on Electrochemical Properties of Severely Deformed Al-5 wt% Cu Alloy by ECAPMaterials Science Forum, 2006
- Effect of the number of ECAP pass time on the electrochemical properties of 1050 Al alloysMaterials Science and Engineering: A, 2004