M. Händel
Research Subjects
M. Händel has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
D. Nickel
Institut für Werkstoffwissenschaft und Werkstofftechnik, Professur Oberflächentechnik / Funktionswerkstoffe, Technische Universität Chemnitz, 09125 Chemnitz
2 shared publications- Thomas Lampke
Materials and Surface Engineering, Institute of Materials Science and Engineering, Chemnitz University of Technology, D-09107 Chemnitz, Germany
2 shared publications G. Alisch
Institut für Werkstoffwissenschaft und Werkstofftechnik, Professur Oberflächentechnik / Funktionswerkstoffe, Technische Universität Chemnitz, 09125 Chemnitz
1 shared publication
Latest Publications
- 23 July 2012
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 43 (7) , 596-600
Micro‐ and macroelectrochemical investigations of the corrosion behavior of an Al/Mg compound
- 23 July 2012
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 43 (7) , 596-600
Micro‐ and macroelectrochemical investigations of the corrosion behavior of an Al/Mg compound
- 13 July 2011
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 42 (7) , 606-611
Effect of different grain sizes and textures on the corrosion behaviour of aluminum alloy AA6082
The fabrication and processing of aluminum alloys can result in the formation of different grain sizes and textures within the material. The effects of these differences on the corrosion behaviour of the commercially available alloy AA6082 have been investigated. The results of the macro‐ and microelectrochemical investigations have been compared with each other and with the resulting corrosion appearance. The observed corrosion damage is not always consistent with the measured corrosion and pitting potential. In the finer‐grained part, with a strongly preferred orientation of (002) planes parallel to the sample surface, less corrosion damage could be observed than in the coarser‐grained part. However, microelectrochemical measurements show a slightly lower pitting potential in the finer‐grained part, so that pitting is likely to start earlier in this area.
- 13 July 2011
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 42 (7) , 606-611
Effect of different grain sizes and textures on the corrosion behaviour of aluminum alloy AA6082
The fabrication and processing of aluminum alloys can result in the formation of different grain sizes and textures within the material. The effects of these differences on the corrosion behaviour of the commercially available alloy AA6082 have been investigated. The results of the macro‐ and microelectrochemical investigations have been compared with each other and with the resulting corrosion appearance. The observed corrosion damage is not always consistent with the measured corrosion and pitting potential. In the finer‐grained part, with a strongly preferred orientation of (002) planes parallel to the sample surface, less corrosion damage could be observed than in the coarser‐grained part. However, microelectrochemical measurements show a slightly lower pitting potential in the finer‐grained part, so that pitting is likely to start earlier in this area.