A Low-Cost Flexure-Based Handheld Mechanism for Micromanipulation
- 27 September 2010
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/ASME Transactions on Mechatronics
- Vol. 16 (4) , 773-778
Abstract
With the advancement in the knowledge of surgical procedures and cell micromanipulation, there is a demand for a handheld instrument to perform micromanipulation. Hence, this paper presents a 3-DOF handheld mechanism for micromanipulation driven by three piezoelectric actuators. Flexure-based joints are utilized because of its advantages like the nonexistence of backlash and assembly errors. However, it is difficult and expensive to make such compact mechanism using traditional machining methods. In addition, the traditional machining methods are limited to simple design. To reduce the cost of fabrication and also to allow more complex designs, Objet (a rapid prototyping machine) is proposed to be used to build the mechanism. With regards to the handheld applications, the size of the mechanism is a constraint. Hence, a parallel manipulator design is the preferred choice because of its rigidity and compactness. For the illustration of an application, the mechanism is designed with an intraocular needle attached to it. Possible applications of this design include enhancement of performance in microsurgery and cell micromanipulation. Experiments are also conducted to evaluate the manipulator's tracking performance of the needle tip at a frequency of 10 Hz.Keywords
This publication has 13 references indexed in Scilit:
- Feedforward Controller of Ill-Conditioned Hysteresis Using Singularity-Free Prandtl–Ishlinskii ModelIEEE/ASME Transactions on Mechatronics, 2009
- Direct kinematics of zero-torsion parallel mechanisms2008
- Feedforward Controller With Inverse Rate-Dependent Model for Piezoelectric Actuators in Trajectory-Tracking ApplicationsIEEE/ASME Transactions on Mechatronics, 2007
- A Large-Displacement 3-DOF Flexure Parallel Mechanism with Decoupled Kinematics Structure2006
- Analysis and design of parallel mechanisms with flexure jointsIEEE Transactions on Robotics, 2005
- Flexure-based Manipulator for Active Handheld Microsurgical Instrument2005
- Toward active tremor canceling in handheld microsurgical instrumentsIEEE Transactions on Robotics and Automation, 2003
- Compliant systems using monolithic mechanismsSmart Materials Bulletin, 2001
- A three-degrees-of-freedom micromotion in-parallel actuated manipulatorIEEE Transactions on Robotics and Automation, 1991
- Kinematic analysis of a three-degrees-of-freedom in-parallel actuated manipulatorIEEE Journal on Robotics and Automation, 1988