REBCO Soldered Lap Joint Resistance Versus Length and Tape Manufacturer
- 15 November 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 35 (5) , 1-4
Abstract
REBCO high-temperature superconductor tapes are made in piece lengths too short for many complete devices such as high-field solenoid magnets, cables, fault limiters, etc. In-line splices are required, and soldering is the preferred method of fabrication. The resistance and contact resistivity of such lap joints is a topic of ongoing investigation. To date it is well understood that the resistance of a soldered REBCO lap joint depends inversely upon the length of the joint in the range practical for devices. It is also well understood that the dominant contributor to the resistance of a lap joint is the interface resistance between the REBCO conductor and its applied silver coating. This property could differ by manufacturer. In this study, a direct comparison is made by fabricating lap joints with REBCO tape from several manufacturers in a range of lengths and measuring the resistance.Keywords
Funding Information
- National Science Foundation Cooperative (DMR-2131790, DMR-2128556)
- State of Florida
This publication has 13 references indexed in Scilit:
- Oxygen out-diffusion in REBCO coated conductor due to heatingSuperconductor Science and Technology, 2021
- In-Field Electrical Resistance at 4.2 K of REBCO SplicesIEEE Transactions on Applied Superconductivity, 2017
- Progress in the Development of a Superconducting 32 T Magnet With REBCO High Field CoilsIEEE Transactions on Applied Superconductivity, 2013
- The 77-K Stress and Strain Dependence of the Critical Current of YBCO Coated Conductors and Lap JointsIEEE Transactions on Applied Superconductivity, 2011
- Lap Joint Resistance of YBCO Coated ConductorsIEEE Transactions on Applied Superconductivity, 2010
- Critical Current Degradation Behavior in Lap-Jointed Coated Conductor Tapes With IBAD Substrate Under Uniaxial TensionIEEE Transactions on Applied Superconductivity, 2010
- VOLTAGE DISTRIBUTION AND MECHANICAL STRENGTH IN SPLICE JOINTS MADE FROM AS-MANUFACTURED YBCO COATED CONDUCTORSAIP Conference Proceedings, 2010
- Evaluation of Electrical Properties of Lap Joints for BSCCO and YBCO TapesIEEE Transactions on Applied Superconductivity, 2009
- Splice Resistance Measurements on 2G YBCO Coated ConductorsIEEE Transactions on Applied Superconductivity, 2009
- Analysis of a Joint Method Between Superconducting YBCO Coated ConductorsIEEE Transactions on Applied Superconductivity, 2007