Corrugated core panels manufactured by methods of superplastic forming concurrent with diffusion bonding (SPF/DB) are promising for the production of high specific strength articles. One of serious problems arising in forming of corrugated core panels is concerned with the formation of the outer folds. The cause of folding is the uneven deformation of the skin sheets. In this study, the process of forming a corrugated core panel from a titanium alloy VT6 (analogue of Ti-6Al-4V) by computer simulation is considered. Finite element modeling is carrying out using ANSYS software. The formulation of the boundary value problem is stated in terms of the theory of creep. It is shown that after completion of the formation of stiffening ribs, it is possible to increase the working pressure to a maximum without damaging the structure. The results of numerical simulation showed that increasing the amount of pressure and holding time helps to eliminate folds. However, the pressure value is technically limited, and increasing the holding time reduces the economic efficiency of the process. It is noted that the process of forming a corrugated core panel has two characteristic stages. In the first stage, the core sheet is deformed under the conditions of superplasticity, stiffening ribs are formed. The first stage continues until the skin sections joined to the core touches the surface of the die. The second stage proceeds under conditions of creep up to smoothing the outer folds.