Seismic response of sliding equipment and contents in base‐isolated buildings subjected to broadband ground motions
- 20 October 2014
- journal article
- research article
- Published by Wiley in Earthquake Engineering & Structural Dynamics
- Vol. 44 (6) , 865-887
Abstract
Summary: Base isolation has been established as the seismic design approach of choice when it comes to protecting nonstructural contents. However, while this protection technology has been widely shown to reduce seismic demands on attached oscillatory equipment and contents (EC), its effectiveness in controlling the response of freestanding EC that are prone to sliding has not been investigated. This study examines the seismic behavior of sliding EC inside base‐isolated buildings subjected to broadband ground motions. The effect of isolation system properties on the response of sliding EC with various friction coefficients is examined. Two widely used isolation models are considered: viscously damped linear elastic and bilinear. The study finds isolation to be generally effective in reducing seismic demands on sliding EC, but it also exposes certain situations where isolation in fact increases demands on EC, most notably for low friction coefficients and high earthquake intensities. Damping at the isolation level is effective in controlling the EC sliding displacements, although damping over about 20% is found to be superfluous. The study identifies a physically motivated dimensionless intensity measure and engineering demand parameter for sliding equipment in base‐isolated buildings subjected to broadband ground motions. Finally, the paper presents easy‐to‐use design fragility curves and an example that illustrates how to use them. Copyright © 2014 John Wiley & Sons, Ltd.Keywords
Funding Information
- Canadian Network for Research and Innovation in Machining Technology, Natural Sciences and Engineering Research Council of Canada
This publication has 41 references indexed in Scilit:
- Full‐scale shaking table test of a base‐isolated medical facility subjected to vertical motionsEarthquake Engineering & Structural Dynamics, 2013
- Approximating peak responses in seismically isolated buildings using generalized modal analysisEarthquake Engineering & Structural Dynamics, 2013
- Bench–shelf system dynamic characteristics and their effects on equipment and contentsEarthquake Engineering & Structural Dynamics, 2006
- Characterizing frictional behavior for use in predicting the seismic response of unattached equipmentSoil Dynamics and Earthquake Engineering, 2005
- Seismic vulnerability of the healthcare system in El Salvador and recovery after the 2001 earthquakes2004
- The rocking spectrum and the limitations of practical design methodologiesEarthquake Engineering & Structural Dynamics, 2002
- Sliding fragility of block‐type non‐structural components. Part 1: Unrestrained componentsEarthquake Engineering & Structural Dynamics, 2002
- Selection of Trimming Proportions for Robust Adaptive Trimmed MeansJournal of the American Statistical Association, 1978
- A Note on the Estimation of the Location Parameter of the Cauchy DistributionJournal of the American Statistical Association, 1966
- A Note on Estimation from a Cauchy SampleJournal of the American Statistical Association, 1964