Pack Aluminizing by Induction Heating: Application to Inconel 718 Produced by Cold Spray Additive Manufacturing
Open Access
- 12 January 2026
- journal article
- Published by IOP Publishing in Materials Research Express
- Vol. 13 (2)
Abstract
This study investigates the formation of aluminide coatings on Inconel 718 (IN718) superalloy produced by Cold Spray Additive Manufacturing (CSAM) using Pack Induction Aluminizing (PIA) process. The advantage of the proposed method is that the aluminizing time, which takes several hours in conventional pack aluminizing performed in furnace, can be reduced to a few tens of minutes. The microstructure, phase evolution, and tribological performance of the resulting coating were also characterized in the study. The results showed that increasing the processing time from 5 min to 10 min increased the coating thickness from approximately 10 µm to 19 µm, resulting in the formation of a double-layered aluminide coating. XRD and EDS analyses determined that the main components of the coating were aluminum-rich intermetallic compounds with an outer layer of Ni(Fe,Cr)Al3 and an inner layer of Ni2(Fe,Cr)Al3, characteristic of a high-activity aluminizing process. The PIA process significantly improved the tribological properties of the IN718 substrate. Specifically, friction coefficient slightly decreased, wear resistance increased, and wear track depth decreased by approximately 80% compared to the uncoated alloy. These findings demonstrate that the PIA method is a highly effective and rapid technique for producing protective, high-performance aluminide coatings on IN718 superalloy fabricated by cold spray additive manufacturing.Keywords
This publication has 3 references indexed in Scilit:
- Post heat treatment optimization of cold spray additive manufactured Inconel 718Scientific Reports, 2025
- Effect of induction heat treatment on microstructure, mechanical and corrosion properties of stainless steel 308 L fabricated using wire arc additive manufacturingScientific Reports, 2024
- Bonding mechanism in cold gas sprayingActa Materialia, 2003