A New Curing-Dependent Viscoelastic Constitutive Model and Stress-Increment Equations for Numerical Simulation Predicting the Cure-Induced Stress of Epoxy Resin
Open Access
Abstract
A cure-dependent viscoelastic constitutive model is developed to describe the stress response of epoxy resin during curing. The progressive formation of the load-carrying network is represented phenomenologically through cure-dependent equilibrium and Maxwell-branch stiffness functions. A one-dimensional history-integral equation is derived and extended to non-isothermal conditions by incorporating temperature-dependent stiffness and reduced-time effects. Explicit stress-increment equations are then obtained for one-dimensional and three-dimensional isotropic materials and implemented in ABAQUS through a UMAT. Two idealized numerical cases are used to verify the consistency between the UMAT results and direct constitutive calculations. An illustrative encapsulation model further shows that different assumptions regarding the curing-dependent stiffness factor produce substantial differences in peak and final stresses. An additional cooling-rate sensitivity analysis shows that increasing the cooling rate increases the magnitude of the final compressive stress because less time is available for viscoelastic relaxation. A formal tensorial extension is also provided for anisotropic thermosetting materials, although it is not numerically assessed. The present results constitute constitutive and numerical verification rather than material-specific experimental validation.Keywords
Funding Information
- Fundamental Research Funds for the Central Universities (WUT:203101002)
- Fundamental Research Funds for the Central Universities (WUT:203201006)
This publication has 45 references indexed in Scilit:
- Modeling‐based characterization for thermal expansion and chemical shrinkage of highly viscous epoxy resin with thermoplastic additives under the curing conditionPolymer Composites, 2024
- Computational modeling and simulation of temperature field evolution during the chemical foaming of epoxy foamsPolymer Engineering & Science, 2024
- Advances on Thermally Conductive Epoxy‐Based Composites as Electronic Packaging Underfill Materials—A ReviewAdvanced Materials, 2022
- A method of automatically obtaining master surfaces of resin matrix composites by time–temperature superpositionPolymer Composites, 2022
- A generalised distributed‐order Maxwell modelMathematical Methods in the Applied Sciences, 2022
- Model free kinetics coupled with finite element method for curing simulation of thermosetting epoxy resinsJournal of Applied Polymer Science, 2018
- Prediction of residual stresses and distortion in carbon fiber‐epoxy composite parts due to curing process using finite element analysisJournal of Applied Polymer Science, 2012
- A small-strain model to simulate the curing of thermosetsComputational Mechanics, 2008
- Residual strain measurement in composites using the cure-referencing methodExperimental Mechanics, 2000
- Stress relaxation behavior of 3501‐6 epoxy resin during curePolymer Engineering & Science, 1996