Control of high-step down voltage converters for voltage regulator modules
- 1 October 2011
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Abstract
New technologies are requiring high step-down conversion voltages. A possible solution to this problem is to use several buck converters connected in cascade; however, a complex control circuitry is required. An alternative solution is to use an n-stage positive output cascade buck converter with a single active switch. This class of converters is suitable for VRM applications where low voltages and high currents are required. A controller design methodology for this class of converters is developed using average current-mode control. The proposed scheme employs the inductor current of the input stage and the capacitor voltage of the output stage; therefore, the full benefits of current-mode control are maintained. Experimental results are given for a 80 W switching regulator where the robustness of the proposed controller is tested under changes on the output load.Keywords
This publication has 7 references indexed in Scilit:
- Modelling and analysis of switch-mode cascade converters with a single active switchIET Power Electronics, 2008
- Average Current-Mode Control Scheme for a Quadratic Buck Converter With a Single SwitchIEEE Transactions on Power Electronics, 2008
- Control loop design for two-stage DC-DC converters with low voltage/high current outputIEEE Transactions on Power Electronics, 2005
- Multiphase coupled-buck converter-a novel high efficient 12 V voltage regulator moduleIEEE Transactions on Power Electronics, 2003
- Buck+half bridge (d=50%) topology applied to very low voltage power converters2002
- Modeling of switch-mode dc-dc cascade convertersIEEE Transactions on Aerospace and Electronic Systems, 2002
- Investigation of candidate VRM topologies for future microprocessorsIEEE Transactions on Power Electronics, 2000