Consideration on Local Heat Transfer Measurement of Plate Heat Exchanger with the Aid of Simulation
Open Access
- 29 February 2020
- journal article
- research article
- Published by Center of Technology (COT) in EPI International Journal of Engineering
- Vol. 3 (1) , 1-9
Abstract
In this study, the local heat transfer coefficient of boiling and condensation were obtained by an experimental set up using vertical stainless-steel type brazed plate heat exchanger. A series of 8 vertical brazed plates are used as the major components of the test section of experimental set up and are fabricated into layers so that flow channels are formed between the plates through which water and refrigerants are flowing through. The experiments are carried out at the mass flux of 10, 20 and 50 kg/(m2žs). In order to measure the local heat transfer coefficient, flat stainless-steel plates of 10 mm in thickness are installed attached to the vertical plates onto which the thermocouples are positioned to measure the temperature distributions at the surface of the plates. By performing the experiment, the direction of the heat flux across the plate tends to deviate downward especially at the lower part of the plate due to the non-uniform temperature distributions across the plate. The results are analyzed and validated at the mass flux of 10 kg/(m2žs) by the aid of the simulation tool by using ANSYS FLUENT 19.1 to estimate the local heat transfer coefficient and the heat flux across the plate. The analysis result shows that the simulation model can assist to track the deviation of the direction of the heat flow from the horizontal direction across the plate and the experimental results of the local heat transfer coefficient have similar trends with that of the simulation results.Keywords
This publication has 12 references indexed in Scilit:
- Heat transfer and frictional pressure drop during condensation in plate heat exchangers: Assessment of correlations and a new methodInternational Journal of Heat and Mass Transfer, 2019
- Experimental investigation on condensation heat transfer and pressure drop of a low GWP refrigerant R-1233zd(E) in a plate heat exchangerInternational Journal of Heat and Mass Transfer, 2019
- Local Condensation Heat Transfer Characteristics of Refrigerant R1234ze(E) Flow Inside a Plate Heat ExchangerInternational Journal of Air-Conditioning and Refrigeration, 2017
- Flow boiling and frictional pressure gradients in plate heat exchangers. Part 1: Review and experimental databaseInternational Journal of Refrigeration, 2016
- Numerical investigation of heat transfer and fluid flow in plate heat exchanger using nanofluidsInternational Journal of Thermal Sciences, 2014
- CFD Simulation of Heat Transfer and Pressure Drop in Compact Brazed Plate Heat ExchangersHeat Transfer Engineering, 2013
- Experimental and theoretical analysis of the local condensation heat transfer in a plate heat exchangerJournal of Physics: Conference Series, 2012
- Condensation heat transfer and pressure drop of refrigerant R-410A flow in a vertical plate heat exchangerInternational Journal of Heat and Mass Transfer, 2005
- Experimental heat transfer coefficients during refrigerant vaporisation and condensation inside herringbone-type plate heat exchangers with enhanced surfacesInternational Journal of Heat and Mass Transfer, 2004
- Condensation Heat Transfer and Pressure Drop of Brazed Plate Heat Exchangers Using Refrigerant R-134aJournal of Enhanced Heat Transfer, 2004