Microstructure and Mechanical Properties of In-Doped Low-Temperature SnPb Solders
Open Access
Abstract
In this paper, In was introduced into SnPb eutectic solder to develop a new low-temperature solder for three-dimensional packaging technology. SnPbIn solders containing 5, 10, 13, 15 and 17 wt.% In were prepared through vacuum induction melting. The effect of the addition of In on the microstructure and thermal and mechanical properties of the SnPbIn solders was investigated. The results showed that the SnPb eutectic solder consisted of Sn(ss) and Pb(ss), but when the In content was higher than 5 wt.%, the SnPbIn solder included Sn(ss) and Pb(ss) and a new InSn4 phase. Solid dissolution of the In element into Sn(ss) and Pb(ss) preferentially occurred. The melting points of the SnPbIn solders gradually decreased with the increasing addition of the In element. The melting point of the Sn-Pb-13In solder decreased to 150.5 °C, which met the requirements of 2.5D packaging. But the cast Sn-Pb-5In solder reached the best tensile strength of 48.8 MPa and elongation of 27.3%. Super-plasticity occurred in the cold-rolled SnPbIn, while the 59.9Sn35.1 Pb5In solder achieved elongation of 382.0% and 408.6%, respectively, at deformation of 70% and 90%. The super-plasticity originated from the recrystallization behavior and soft orientation.Keywords
This publication has 16 references indexed in Scilit:
- Atomic scale investigation of interfacial damage initiation in SnPb alloy: structural stability and defect-interface interactionsJournal of Materials Science, 2024
- Effects of Ni-decorated reduced graphene oxide nanosheets on the microstructural evolution and mechanical properties of Sn-3.0Ag-0.5Cu composite soldersIntermetallics, 2022
- Electronic module assemblyCIRP Annals, 2021
- Influence of Indium on Microstructure and Properties of Sn-Pb Binary Alloy Applied in Photovoltaic RibbonJournal of Materials Engineering and Performance, 2019
- The interfacial reaction between In-48Sn solder and polycrystalline Cu substrate during solid state agingJournal of Alloys and Compounds, 2018
- Effect of In on microstructure, thermodynamic characteristic and mechanical properties of Sn–Bi based lead-free solderJournal of Alloys and Compounds, 2015
- Microstructural evolution in two-phase alloys processed by high-pressure torsionJournal of Materials Science, 2012
- Effects of Trace Amounts of Rare Earth Additions on Microstructure and Properties of Sn-Bi-Based Solder AlloyJournal of Electronic Materials, 2008
- Interfacial reactions between molten Sn–Bi–X solders and Cu substrates for liquid solder interconnectsActa Materialia, 2006
- New lead-free, Sn-Zn-In solder alloysJournal of Electronic Materials, 1994