THE STRESS ANALYSIS ON TWO DIFFERENT ADHESIVELY BONDED T-JOINTS VIA 3D NONLINEAR FINITE ELEMENT METHOD
- 30 March 2020
- journal article
- conference paper
- Published by Yildiz Technical University in Journal of Thermal Engineering
- Vol. 6 (2) , 170-179
Abstract
Adhesively bonded joints are formed in different configurations. T- adhesively bonded joint is one of these configurations and has an important position in industrial applications. The purpose of this study was to numerically study the stress distributions, strength, damage evolution of different T-joints with or without adhesive filling at the curvature of the L-shaped adherends under tensile load via 3D nonlinear finite element method. Here, type-I T-joint is the first model without adhesive filling at the curvature of the L-shaped adherends and type-II T-joint is the second model with adhesive filling at the curvature of the L-shaped adherends. In this study, FM73 and 3M 2214 adhesives and AA2024-T3 aluminum alloy adherends have been used to create two different T-joints numerically. Numerical analysis results have shown that the presence of filler adhesive has a direct influence on joint strength. It has also been observed that ABCD interface is the most critical region in terms of damage occurrence, while is AB and BC lines on the ABCD interface are the most critical lines. In addition, it was observed upon comparing the stress distributions of lines AB and BC that the shear and normal stress values decreased in lines AB and BC of the type-II T-joints. Therefore, it can be put forth that the strength of Type-II T-joints is greater in comparison with the strength of type-I T-joints and the use of a type-II T-joints is more suitable for loads which are close to the fracture load of the T-joints.Keywords
Funding Information
- Erzurum Teknik Üniversitesi (2017-9)
This publication has 18 references indexed in Scilit:
- Failure of adhesively bonded metallic T-joints subjected to quasi-static and crash loadingEngineering Failure Analysis, 2015
- Predicting the Strength of Adhesively Bonded T-joints Under Cyclic Temperature using a Cohesive Zone ModelThe Journal of Adhesion, 2015
- The strength of the adhesively bonded T-joints with embedded supportsInternational Journal of Adhesion and Adhesives, 2014
- Effect of adhesive thickness on adhesively bonded T-jointIOP Conference Series: Materials Science and Engineering, 2013
- Finite element modelling of z-pinned composite T-jointsComposites Science and Technology, 2012
- Numerical analysis of adhesively bonded T-joints with structural sandwiches and study of design parametersInternational Journal of Adhesion and Adhesives, 2011
- Behaviour of Bi-adhesive JointsJournal of Adhesion Science and Technology, 2010
- 3-D Nonlinear Stress Analysis on Adhesively Bonded Single Lap Composite Joints with Different Ply Stacking SequencesThe Journal of Adhesion, 2008
- The strength of adhesively bonded T-jointsInternational Journal of Adhesion and Adhesives, 2002
- Analysis and design of tee joints with double supportInternational Journal of Adhesion and Adhesives, 1996