Control of weld composition when arc welding high strength aluminium alloys using multiple filler wires
Authors:
- 1 August 2010
- journal article
- Published by SAGE Publications in Science and Technology of Welding and Joining
- Vol. 15 (6) , 491-496
Abstract
An experimental method of controlling weld composition when welding Al2024 has been explored. Utilising the tandem process and a cold wire feed unit, two and three commercially available filler wires were mixed in a single weld pool to control composition. Thermodynamic modelling was used to provide optimum weld compositions for the eradication of solidification cracking. Validation showed that by controlling the principal elements, not only was cracking eliminated, the mechanical properties of the weld could be varied. In particular, a composition was identified, which offered adequate joint strength and ductility. Exceeding this composition resulted in a corresponding increase in weld hardness at the expense of joint ductility.Keywords
This publication has 5 references indexed in Scilit:
- Control of weld composition when welding high strength aluminium alloy using the tandem processScience and Technology of Welding and Joining, 2009
- Friction stir welding and processingMaterials Science and Engineering: R: Reports, 2005
- Influence of welding speed on the fatigue of friction stir welds, and comparison with MIG and TIGInternational Journal of Fatigue, 2003
- Welding Metallurgy2002
- The welding of aluminium and its alloys2002