Control of weld composition when welding high strength aluminium alloy using the tandem process
- 1 November 2009
- journal article
- research article
- Published by SAGE Publications in Science and Technology of Welding and Joining
- Vol. 14 (8) , 734-739
Abstract
A new cost effective process for generating different weld element compositions has been examined. Utilising tandem welding technology, different series aluminium filler wires were mixed in a single weld pool with the result that the composition of the principal alloy elements, copper and magnesium were accurately controlled. Thermodynamic modelling was then used to predict an optimum weld bead composition for eliminating solidification cracking when welding Al2024. In order to validate the predicted target composition, the tandem process was used to control the composition of the weld bead. The presented results show that using this system to deposit a controlled ternary composition weld, solidification cracking was eliminated when welding highly constrained test pieces. In contrast, cracking was evident when using commercially available binary filler wires under the same conditions.Keywords
This publication has 9 references indexed in Scilit:
- Friction stir welding of aluminium 7136-T76511 extrusionsScience and Technology of Welding and Joining, 2008
- Effect of initial temper on mechanical properties of friction stir welded Al-2024 alloyScience and Technology of Welding and Joining, 2007
- Fatigue properties of friction stir welds in Al 5083 alloyScripta Materialia, 2005
- Friction stir welding and processingMaterials Science and Engineering: R: Reports, 2005
- Improving mechanical properties of 2219 aluminium alloy GTA welds by scandium additionScience and Technology of Welding and Joining, 2005
- Influence of scandium on weldability of 7010 aluminium alloyScience and Technology of Welding and Joining, 2005
- Selection of filler wire for arc welding aluminium alloys of the Al–Mg and Al–Cu systemsWelding International, 2003
- Development of new high strength Al – Sc filler wires for fusion welding 7000 series aluminium aerospace alloysScience and Technology of Welding and Joining, 2003
- Effect of scandium and titanium–boron on grain refinement and hot cracking of aluminium alloy 7108Science and Technology of Welding and Joining, 1999