Masterbatch‐Assisted Fabrication of Polylactic Acid/Reduced Graphene Oxide Nanocomposites Exhibiting Mechanical Enhancement and UV ‐C Aging Resistance
Open Access
- 5 April 2026
- journal article
- Published by Wiley in Polymer Composites
- Vol. 47 (13) , 12086-12096
Abstract
Polylactic acid (PLA) is a promising bio‐based polymer; nonetheless, its extensive application is still limited by poor fracture toughness, low thermal stability, and strong susceptibility to degradation induced by ultraviolet (UV) radiation. In this study, nanocomposites of PLA with reduced graphene oxide (rGO) were prepared through a masterbatch dilution approach. First, a PLA/2 wt% was produced by twin‐screw extrusion, a process compatible with current industrial practices. The masterbatch was subsequently diluted with neat PLA via melt compounding and processed into films by compression molding. The structural, thermal, mechanical, and aging behaviors of the PLA/rGO nanocomposites were systematically investigated, showing improvement compared to neat polymer. The presence of rGO was found to influence the mechanical and thermo‐mechanical response, with both Young's modulus and the storage modulus increasing with filler content, reaching values up to 20%–25% higher than those of neat PLA. Notably, the nanocomposites presented strong resistance to accelerated UV‐C aging; while neat PLA underwent severe cracking, showing a reduction of glass transition temperature of ca. 14°C, and complete mechanical failure, the composites retained their initial morphology and preserved their initial mechanical performance to a great extent, maintaining up to 73% of the original Young's modulus and up to 94% of initial tensile strength. These findings highlight the potential of the masterbatch route for producing durable PLA nanocomposites through industrially compatible processing routes, thus extending the applicability of this bio‐based polymer in several fields, such as automotive and consumer products.Keywords
This publication has 45 references indexed in Scilit:
- Effect of seawater aging on mechanical, buckling, structural, and thermal properties of nano Al2O3 and TiO2‐doped glass‐epoxy nanocompositesPolymer Composites, 2024
- Exploring the influence of graphene incorporation on the characteristics of 3D-printed PLAThe International Journal of Advanced Manufacturing Technology, 2024
- Novel advancements in additive manufacturing of PLA: A reviewPolymer Engineering & Science, 2023
- Effect of long‐term stress aging on aluminum‐BFRP hybrid adhesive joint's mechanical performance: Static and dynamic loading scenariosPolymer Composites, 2022
- Sustainable, Renewable, and Biodegradable Poly(Lactic Acid) Fibers and Their Latest Developments in the Last Decade2020
- Facile dispersion of exfoliated graphene/PLA nanocomposites via in situ polycondensation with a melt extrusion process and its rheological studiesJournal of Applied Polymer Science, 2018
- Thermal conductivity and degradation behavior of HDPE/graphene nanocompositesJournal of Thermal Analysis and Calorimetry, 2017
- Effect of compounding method and processing conditions on the electrical response of exfoliated graphite nanoplatelet/polylactic acid nanocomposite filmsJournal of Materials Science, 2015
- Synergistic effect of lactic acid oligomers and laminar graphene sheets on the barrier properties of polylactide nanocomposites obtained by thein situpolymerization pre‐incorporation methodJournal of Applied Polymer Science, 2015
- Mechanical investigation of confined amorphous phase in semicrystalline polymers: Case of PET and PLAPolymer Engineering & Science, 2014