Strength and Durability of Epoxy-Aluminum Joints
- 15 April 2010
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 86 (4) , 409-429
Abstract
The adhesive strength and durability of adhesively-bonded aluminum joints in wet environments was analyzed. A2024-T4 alloy was subjected to two different surface treatments based on etching with chromic-sulfuric acid (FPL) and with sulfuric acid-ferric sulfate (P2). Small differences were observed in the lap shear strength as a function of the applied surface treatment. However, durability in humid environments was higher for the joints whose adherends were treated with P2. Although the amount of water absorbed by the epoxy adhesive is lower in saline environments, the effects on the glass transition temperature of the epoxy adhesive and on the lap shear strength of the joints are more marked than the effects caused by aging with distilled water. Finally, a new epoxy adhesive with a siloxanic hardener was tested, obtaining good mechanical properties, high glass transition temperature, moderate values of lap shear strength, and high durability in wet environments.Keywords
This publication has 20 references indexed in Scilit:
- Fully-coupled nonlinear analysis of single lap adhesive jointsInternational Journal of Solids and Structures, 2007
- The effects of surface pretreatment on the cyclic-fatigue characteristics of bonded aluminium-alloy jointsInternational Journal of Adhesion and Adhesives, 2006
- The effect of surface pretreatment and moisture on the fatigue performance of adhesively-bonded aluminiumJournal of Materials Processing Technology, 2004
- Molecular structure of interfaces formed with plasma-polymerized silica-like primer films: Part III. Mechanical strength and environmental durability of the primer/aluminum and primer/titanium interfacesThe Journal of Adhesion, 2002
- Pre-treatment of AA6060 aluminium alloy for adhesive bondingInternational Journal of Adhesion and Adhesives, 2002
- Joining techniques for aluminium spaceframes used in automobilesJournal of Materials Processing Technology, 2000
- The Fatigue and Durability Behaviour of Automotive Adhesives. Part III: Predicting the Service LifeThe Journal of Adhesion, 1998
- Review of surface pretreatments for aluminium alloysInternational Journal of Adhesion and Adhesives, 1996
- Pretreatment of aluminium: topography, surface chemistry and adhesive bond durabilityInternational Journal of Adhesion and Adhesives, 1995
- Subadhesive hydration of aluminum adherends and its detection by electrochemical impedance spectroscopyJournal of Adhesion Science and Technology, 1995