A Hybrid Dynamic Model for the Thermal Compressor Heat Pump and Validation with Experimental Data
Open Access
Abstract
Thermally driven heat pumps primarily use thermal energy to drive a compression cycle. The thermal energy can be waste heat, natural-gas combustion, or solar, helping increase efficiency and reduce greenhouse-gas emissions. We study a thermal compressor heat pump (TCHP) in which Stirling-type thermal compressors (TCs) are heat-driven rather than electrically driven, delivering a nominal heat capacity of 8 kW with CO2 as the refrigerant. Unlike most existing dynamic models of CO2 cycles, which focus on electrically driven or single-stage systems, this work targets a heat-driven multi-stage configuration and includes transient validation. Like any vapor compression cycle (VCC), a TCHP requires a dynamic model for control and optimization; its predictive reliability must be validated on experimental data. We therefore describe the test bench and performance expressions, collect steady-state and transient datasets, and derive a hybrid dynamic model: finite-volume (FV) differential equations for slow components and quasi-static submodels (linear regressions and correlations) for fast elements. The contribution of this work is the development and experimental validation of a hybrid FV model for a multi-stage heat-driven CO2 TCHP. Validation against both steady-state and transient datasets shows good agreement. On 15 steady-state operating points, the model reproduces pressures within ∼1 bar mean absolute error (MAE) and system-level performance (total recovered heat, ) within ∼6% mean absolute percentage error (MAPE), with ; component heat-rate predictions are within ∼20% MAPE. Under transient step tests on expansion valve openings and burner fan speed, the thermal COP and total recovered heat track within MAPE (up to ), pressures within bar MAE, and the evaporator heat rate within 14– MAPE.
Keywords
Funding Information
- Association Nationale Recherche Technologie—ANRT (N°2022/0549)
This publication has 19 references indexed in Scilit:
- Dynamic simulation and experimental validation of a 35 MW heat pump based on a transcritical CO2 cycleEnergy, 2024
- Dynamic Modeling of a Vapor Compression CycleIFAC-PapersOnLine, 2022
- Transient modeling of a flash tank vapor injection heat pump system – Part I: Model developmentInternational Journal of Refrigeration, 2015
- Review of modeling methods for HVAC systemsApplied Thermal Engineering, 2014
- A comparison of moving-boundary and finite-volume formulations for transients in centrifugal chillersInternational Journal of Refrigeration, 2008
- An advanced nonlinear switched heat exchanger model for vapor compression cycles using the moving-boundary methodInternational Journal of Refrigeration, 2008
- New flow boiling heat transfer model and flow pattern map for carbon dioxide evaporating inside horizontal tubesInternational Journal of Heat and Mass Transfer, 2006
- Unsteady compressible two-phase flow model for predicting cyclic heat pump performance and a comparison with experimental dataInternational Journal of Refrigeration, 1989
- A simulation model of the transient performance of a heat pumpInternational Journal of Refrigeration, 1982
- A general correlation for heat transfer during film condensation inside pipesInternational Journal of Heat and Mass Transfer, 1979