Pascal Dufour
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Pascal Dufour has a total of 110 co-authors. Here are the top co-authors by number of shared publications:
- Madiha Nadri
LIRIS CNRS France
17 shared publications Antonio Sciarretta
Control, Signal and System Department, IFP Energies Nouvelles, Rueil-Malmaison, France
5 shared publications- Vincent Lemort
Thermodynamics Laboratory, University of Liège, Liège, Belgium
5 shared publications Chouaib Afri
Université de Lyon, Lyon, France
4 shared publicationsH. Hammouri
4 shared publicationsJohan Peralez
Université de Lyon, Lyon, France
4 shared publications
Latest Publications
- Open Access
A Hybrid Dynamic Model for the Thermal Compressor Heat Pump and Validation with Experimental Data
Thermally driven heat pumps primarily use thermal energy to drive a compression cycle. The thermal energy can be waste heat, natural-gas combustion, or solar, helping increase efficiency and reduce greenhouse-gas emissions. We study a thermal compressor heat pump (TCHP) in which Stirling-type thermal compressors (TCs) are heat-driven rather than electrically driven, delivering a nominal heat capacity of 8 kW with CO2 as the refrigerant. Unlike most existing dynamic models of CO2 cycles, which focus on electrically driven or single-stage systems, this work targets a heat-driven multi-stage configuration and includes transient validation. Like any vapor compression cycle (VCC), a TCHP requires a dynamic model for control and optimization; its predictive reliability must be validated on experimental data. We therefore describe the test bench and performance expressions, collect steady-state and transient datasets, and derive a hybrid dynamic model: finite-volume (FV) differential equations for slow components and quasi-static submodels (linear regressions and correlations) for fast elements. The contribution of this work is the development and experimental validation of a hybrid FV model for a multi-stage heat-driven CO2 TCHP. Validation against both steady-state and transient datasets shows good agreement. On 15 steady-state operating points, the model reproduces pressures within ∼1 bar mean absolute error (MAE) and system-level performance (total recovered heat, ) within ∼6% mean absolute percentage error (MAPE), with ; component heat-rate predictions are within ∼20% MAPE. Under transient step tests on expansion valve openings and burner fan speed, the thermal COP and total recovered heat track within MAPE (up to ), pressures within bar MAE, and the evaporator heat rate within 14– MAPE.Open AccessA Hybrid Dynamic Model for the Thermal Compressor Heat Pump and Validation with Experimental Data
Thermally driven heat pumps primarily use thermal energy to drive a compression cycle. The thermal energy can be waste heat, natural-gas combustion, or solar, helping increase efficiency and reduce greenhouse-gas emissions. We study a thermal compressor heat pump (TCHP) in which Stirling-type thermal compressors (TCs) are heat-driven rather than electrically driven, delivering a nominal heat capacity of 8 kW with CO2 as the refrigerant. Unlike most existing dynamic models of CO2 cycles, which focus on electrically driven or single-stage systems, this work targets a heat-driven multi-stage configuration and includes transient validation. Like any vapor compression cycle (VCC), a TCHP requires a dynamic model for control and optimization; its predictive reliability must be validated on experimental data. We therefore describe the test bench and performance expressions, collect steady-state and transient datasets, and derive a hybrid dynamic model: finite-volume (FV) differential equations for slow components and quasi-static submodels (linear regressions and correlations) for fast elements. The contribution of this work is the development and experimental validation of a hybrid FV model for a multi-stage heat-driven CO2 TCHP. Validation against both steady-state and transient datasets shows good agreement. On 15 steady-state operating points, the model reproduces pressures within ∼1 bar mean absolute error (MAE) and system-level performance (total recovered heat, ) within ∼6% mean absolute percentage error (MAPE), with ; component heat-rate predictions are within ∼20% MAPE. Under transient step tests on expansion valve openings and burner fan speed, the thermal COP and total recovered heat track within MAPE (up to ), pressures within bar MAE, and the evaporator heat rate within 14– MAPE. - 1 January 2023
- Published by Optica Publishing Group
- p. Th6.53
Narrow-Linewidth Semiconductor Laser With Highly Linear Frequency Modulation Response for Coherent Sensing
A semiconductor DFB laser with a linewidth under 10 kHz, output power over 60 mW and linear frequency modulation span over 7 GHz is presented. Demonstrations of applications in lidar and distributed sensing are shown.
- 1 January 2023
- Published by Optica Publishing Group
- p. Th6.53
Narrow-Linewidth Semiconductor Laser With Highly Linear Frequency Modulation Response for Coherent Sensing
A semiconductor DFB laser with a linewidth under 10 kHz, output power over 60 mW and linear frequency modulation span over 7 GHz is presented. Demonstrations of applications in lidar and distributed sensing are shown.
- 6 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automatic Control
- Vol. 65 (12) , 5205-5219
Observer Design for Nonlinear Systems With Output Transformation
This article addresses the problem of robust observer design for nonlinear systems with transformed output. We first assume that there exists an observer design for a given nonlinear system. The structure of the system output is often crucial for estimating the system states. Therefore, we consider the problem that arises when the output is only available under a nonlinear transformation (affected by noise). This formulation is especially useful in engineering applications, where nonlinear sensors are frequent. We propose a new interconnected observer that estimates both the unavailable output and the system states, and we establish small-gain type conditions ensuring the asymptotic convergence of the overall error dynamics. To explicit our design parameters, we study the particular cases of state-affine systems up to output injection and systems with additive triangular nonlinearities. Finally, we provide corresponding numerical examples and comparisons with known observers.
- 6 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automatic Control
- Vol. 65 (12) , 5205-5219
Observer Design for Nonlinear Systems With Output Transformation
This article addresses the problem of robust observer design for nonlinear systems with transformed output. We first assume that there exists an observer design for a given nonlinear system. The structure of the system output is often crucial for estimating the system states. Therefore, we consider the problem that arises when the output is only available under a nonlinear transformation (affected by noise). This formulation is especially useful in engineering applications, where nonlinear sensors are frequent. We propose a new interconnected observer that estimates both the unavailable output and the system states, and we establish small-gain type conditions ensuring the asymptotic convergence of the overall error dynamics. To explicit our design parameters, we study the particular cases of state-affine systems up to output injection and systems with additive triangular nonlinearities. Finally, we provide corresponding numerical examples and comparisons with known observers.
- 1 January 2019
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 52 (5) , 478-483
Evaluation of a Coupled Organic Rankine Cycle Mild Hybrid Architecture for Long-Haul Heavy-Duty Truck
- 1 January 2019
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 52 (5) , 478-483
Evaluation of a Coupled Organic Rankine Cycle Mild Hybrid Architecture for Long-Haul Heavy-Duty Truck
- 1 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2170-2175
Observer Design for Nonlinear Systems with Implicit Output
This paper investigates the problem of observer design for nonlinear systems when only a transformed output is available for measurement. More precisely, we first assume that there exists an observer design that requires the output of the system. We then suppose that this disturbed output is only available under a transformation and we propose a new observer design. We establish small-gain type conditions ensuring the asymptotic convergence of the proposed observer and we provide an illustration example.
- 1 December 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2170-2175
Observer Design for Nonlinear Systems with Implicit Output
This paper investigates the problem of observer design for nonlinear systems when only a transformed output is available for measurement. More precisely, we first assume that there exists an observer design that requires the output of the system. We then suppose that this disturbed output is only available under a transformation and we propose a new observer design. We establish small-gain type conditions ensuring the asymptotic convergence of the proposed observer and we provide an illustration example.
- 8 November 2018
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 51 (31) , 726-731
Experiment Design for Waste Heat Recovery Modeling in Heavy Duty Trucks
- 8 November 2018
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 51 (31) , 726-731
Experiment Design for Waste Heat Recovery Modeling in Heavy Duty Trucks
- 1 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2733-2738
Optimal observer design for disturbed state affine systems
- 1 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2733-2738
Optimal observer design for disturbed state affine systems
- Open Access
- 24 February 2018
- Published by Springer Nature in Journal of Electroceramics
- Vol. 40 (3) , 197-202
Microstructure and electrical properties of (Ba0.6Sr0.4)0.85Bi0.1TiO3 ceramics prepared by single-step, liquid-phase, solid-state reactive sintering
- 24 February 2018
- Published by Springer Nature in Journal of Electroceramics
- Vol. 40 (3) , 197-202
Open AccessMicrostructure and electrical properties of (Ba0.6Sr0.4)0.85Bi0.1TiO3 ceramics prepared by single-step, liquid-phase, solid-state reactive sintering
- Open Access
- 23 September 2016
- Published by Taylor & Francis in International Journal of Control
- Vol. 90 (4) , 873-887
Optimal input design for parameter estimation of nonlinear systems: case study of an unstable delta wing
A closed-loop optimal experimental design for online parameter identification approach is developed for nonlinear dynamic systems. The goal of the observer and the nonlinear model predictive control theories is here to perform online computation of the optimal time-varying input and to estimate the unknown model parameters online. The main contribution consists in combining Lyapunov stability theory with an existing closed-loop identification approach, in order to maximise the information content in the experiment and meanwhile to asymptotically stabilise the closed-loop system. To illustrate the proposed approach, the case of an open-loop unstable aerodynamic mechanical system is discussed. The simulation results show that the proposed algorithm allows to estimate all unknown parameters, which was not possible according to previous work, while keeping the closed-loop system stable.
- 23 September 2016
- Published by Taylor & Francis in International Journal of Control
- Vol. 90 (4) , 873-887
Open AccessOptimal input design for parameter estimation of nonlinear systems: case study of an unstable delta wing
A closed-loop optimal experimental design for online parameter identification approach is developed for nonlinear dynamic systems. The goal of the observer and the nonlinear model predictive control theories is here to perform online computation of the optimal time-varying input and to estimate the unknown model parameters online. The main contribution consists in combining Lyapunov stability theory with an existing closed-loop identification approach, in order to maximise the information content in the experiment and meanwhile to asymptotically stabilise the closed-loop system. To illustrate the proposed approach, the case of an open-loop unstable aerodynamic mechanical system is discussed. The simulation results show that the proposed algorithm allows to estimate all unknown parameters, which was not possible according to previous work, while keeping the closed-loop system stable.
- 21 June 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 25 (3) , 952-965
Organic Rankine Cycle for Vehicles: Control Design and Experimental Results
The system considered here is an organic Rankine cycle for recovering waste heat from a heavy-duty diesel engine. Because of the highly transient conditions these systems are subject to, control plays a fundamental role to enable the viability and efficiency of those systems. In this context, this paper investigates the problem of control design for superheating (SH) and pressure at evaporator outlet. Based on a moving boundary heat exchanger model, a first controller, which consists of a dynamic feedforward combined to a gain-scheduled PID, is implemented on the pump speed to maintain the SH close to the set-point value. Experimental results illustrate the enhanced performance in terms of disturbance rejection. Then, a second controller based on nonlinear state estimation is proposed. This is a nonlinear feedback law, which allows to adjust the evaporating pressure to time-varying demand with a good accuracy.
- 21 June 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 25 (3) , 952-965
Organic Rankine Cycle for Vehicles: Control Design and Experimental Results
The system considered here is an organic Rankine cycle for recovering waste heat from a heavy-duty diesel engine. Because of the highly transient conditions these systems are subject to, control plays a fundamental role to enable the viability and efficiency of those systems. In this context, this paper investigates the problem of control design for superheating (SH) and pressure at evaporator outlet. Based on a moving boundary heat exchanger model, a first controller, which consists of a dynamic feedforward combined to a gain-scheduled PID, is implemented on the pump speed to maintain the SH close to the set-point value. Experimental results illustrate the enhanced performance in terms of disturbance rejection. Then, a second controller based on nonlinear state estimation is proposed. This is a nonlinear feedback law, which allows to adjust the evaporating pressure to time-varying demand with a good accuracy.